Forum for Science, Industry and Business

Sponsored by:     3M 
Search our Site:

 

Mixing Processes Could Increase the Impact of Biofuel Spills on Aquatic Environments

19.11.2012
Ethanol, a component of biofuel made from plants such as corn, is blended with gas in many parts of the country, but has significantly different fluid properties than pure gasoline.

A group of researchers from the University of Michigan wondered how ethanol-based fuels would spread in the event of a large aquatic spill. They found that ethanol-based liquids mix actively with water, very different from how pure gasoline interacts with water and potentially more dangerous to aquatic life.

The scientists will present their results, which could impact the response guidelines for ethanol fuel-based spills, at the American Physical Society’s (APS) Division of Fluid Dynamics (DFD) meeting, held Nov. 18 – 20, in San Diego, Calif.

“Ethanol/gasoline blends are often presented as more environmentally benign than pure gasoline, but there is, in fact, little scientific research into the effects these blends could have on the health of surface waters,” says Avery Demond, an associate professor and director of the Environmental and Water Resources Engineering program at the University of Michigan, and one of the researchers who is working on the project. Some reports written for the State of California include methods for calculating the spread of ethanol into water based on a passive diffusion/dispersion process, notes Demond, but the method was not based on strong scientific evidence of how the two fluids interact.

The Michigan researchers were motivated to fill some of the knowledge gaps. They experimented by filling a tank with water, covering the water with a plate, and pouring ethanol mixtures on top. The plate was then pulled away and the researchers recorded videos of the two fluids as they began to mix. The videos showed flow patterns called convection cells forming at the interface of the ethanol mixture and water. The mixing of the two fluids produced heat that changed the density and viscosity of the fluid, giving rise to circulation currents. In contrast, pure gasoline is essentially insoluble in water and primarily remains on the surface where it vaporizes into the air.

“The mixing behavior [of ethanol-based fuel mixtures and water], from my perspective, is very unusual,” says Demond. “I’ve never seen anything quite like it and it certainly is not passive the way that modeling guidelines suggest.” Aline Cotel, also an associate professor at the University of Michigan and another member of the research team, will present videos of the unusual mixing patterns at the conference.

As a next step, the researchers would like to study how different ethanol mixtures vaporize, helping them to determine how much of a spill would end up mixed into the water and how much would volatilize into the air. Although ethanol is biodegradable, in high concentrations it can be toxic to fish and other aquatic life. The ethanol in ethanol/gasoline blends might also transport some of the carcinogenic components of gasoline into the water during the mixing process.

“We can’t make statements about the environmental impact of ethanol before we’ve more fully investigated its potential effects on surface water quality in the event of a spill,” note the researchers.

Ultimately, they hope their work will help answer outstanding questions about how ethanol mixes with water, giving scientists and policy makers a firmer grasp of the potential risks of ethanol-based biofuels.

Presentation: “Characterization of Mixing Between Water and Biofuels,” is at 9:31 a.m. on Tuesday, Nov. 20, in room 23A.

Abstract: http://meeting.aps.org/Meeting/DFD12/Event/178765

MORE MEETING INFORMATION
The 65th Annual Meeting of the American Physical Society (APS) Division of Fluid Dynamics will take place from November 18-20, 2012, in San Diego, Calif. It will bring together researchers from across the globe to address some of the most important questions in modern astronomy, engineering, alternative energy, biology, and medicine. All meeting information, including directions to the Convention Center, is at: http://apsdfd2012.ucsd.edu/
USEFUL LINKS
Main Meeting Web Site: http://apsdfd2012.ucsd.edu/
Searchable Abstracts: http://meeting.aps.org/Meeting/DFD12/APS_epitome
Directions and Maps: http://apsdfd2012.ucsd.edu/?page=Venue_and_Maps
PRESS REGISTRATION
Credentialed full-time journalists and professional freelance journalists working on assignment for major publications or media outlets are invited to attend the conference free of charge. If you are a reporter and would like to attend, please contact Charles Blue (dfdmedia@aps.org, 301-209-3091).
SUPPORT DESK FOR REPORTERS
A media-support desk will be available. Press announcements and other news will be available in the Virtual Press Room (see below).
VIRTUAL PRESS ROOM
The APS Division of Fluid Dynamics Virtual Press Room will be launched in mid-November and will feature news releases, graphics, videos, and other information to aid in covering the meeting on site and remotely. See: http://www.aps.org/units/dfd/pressroom/index.cfm
GALLERY OF FLUID MOTION
Every year, the APS Division of Fluid Dynamics hosts posters and videos that show evocative images and graphics from either computational or experimental studies of flow phenomena. The outstanding entries are selected for their artistic content, originality, and ability to convey information. They will be honored during the meeting, placed on display at the 2013 APS March Meeting, and appear in the annual Gallery of Fluid Motion article in the American Institute of Physics' journal, Physics of Fluids.

Selected entries from the Gallery of Fluid Motion will be hosted as part of the Fluid Dynamics Virtual Press Room. In mid-November, when the Virtual Press Room is launched, another announcement will be sent out.

This release was prepared by the American Institute of Physics (AIP) on behalf of the American Physical Society’s (APS) Division of Fluid Dynamics (DFD).

ABOUT THE APS DIVISION OF FLUID DYNAMICS
The Division of Fluid Dynamics of the American Physical Society (APS) exists for the advancement and diffusion of knowledge of the physics of fluids with special emphasis on the dynamical theories of the liquid, plastic and gaseous states of matter under all conditions of temperature and pressure. See: http://www.aps.org/units/dfd/

Charles Blue | Newswise Science News
Further information:
http://www.aps.org

More articles from Ecology, The Environment and Conservation:

nachricht How to detect water contamination in situ?
22.09.2016 | Tomsk Polytechnic University (TPU)

nachricht Quantifying the chemical effects of air pollutants on oxidative stress and human health
12.09.2016 | Max-Planck-Institut für Chemie

All articles from Ecology, The Environment and Conservation >>>

The most recent press releases about innovation >>>

Die letzten 5 Focus-News des innovations-reports im Überblick:

Im Focus: OLED microdisplays in data glasses for improved human-machine interaction

The Fraunhofer Institute for Organic Electronics, Electron Beam and Plasma Technology FEP has been developing various applications for OLED microdisplays based on organic semiconductors. By integrating the capabilities of an image sensor directly into the microdisplay, eye movements can be recorded by the smart glasses and utilized for guidance and control functions, as one example. The new design will be debuted at Augmented World Expo Europe (AWE) in Berlin at Booth B25, October 18th – 19th.

“Augmented-reality” and “wearables” have become terms we encounter almost daily. Both can make daily life a little simpler and provide valuable assistance for...

Im Focus: Artificial Intelligence Helps in the Discovery of New Materials

With the help of artificial intelligence, chemists from the University of Basel in Switzerland have computed the characteristics of about two million crystals made up of four chemical elements. The researchers were able to identify 90 previously unknown thermodynamically stable crystals that can be regarded as new materials. They report on their findings in the scientific journal Physical Review Letters.

Elpasolite is a glassy, transparent, shiny and soft mineral with a cubic crystal structure. First discovered in El Paso County (Colorado, USA), it can also be...

Im Focus: Complex hardmetal tools out of the 3D printer

For the first time, Fraunhofer IKTS shows additively manufactured hardmetal tools at WorldPM 2016 in Hamburg. Mechanical, chemical as well as a high heat resistance and extreme hardness are required from tools that are used in mechanical and automotive engineering or in plastics and building materials industry. Researchers at the Fraunhofer Institute for Ceramic Technologies and Systems IKTS in Dresden managed the production of complex hardmetal tools via 3D printing in a quality that are in no way inferior to conventionally produced high-performance tools.

Fraunhofer IKTS counts decades of proven expertise in the development of hardmetals. To date, reliable cutting, drilling, pressing and stamping tools made of...

Im Focus: Launch of New Industry Working Group for Process Control in Laser Material Processing

At AKL’16, the International Laser Technology Congress held in May this year, interest in the topic of process control was greater than expected. Appropriately, the event was also used to launch the Industry Working Group for Process Control in Laser Material Processing. The group provides a forum for representatives from industry and research to initiate pre-competitive projects and discuss issues such as standards, potential cost savings and feasibility.

In the age of industry 4.0, laser technology is firmly established within manufacturing. A wide variety of laser techniques – from USP ablation and additive...

Im Focus: New laser joining technologies at ‘K 2016’ trade fair

Every three years, the plastics industry gathers at K, the international trade fair for plastics and rubber in Düsseldorf. The Fraunhofer Institute for Laser Technology ILT will also be attending again and presenting many innovative technologies, such as for joining plastics and metals using ultrashort pulse lasers. From October 19 to 26, you can find the Fraunhofer ILT at the joint Fraunhofer booth SC01 in Hall 7.

K is the world’s largest trade fair for the plastics and rubber industry. As in previous years, the organizers are expecting 3,000 exhibitors and more than...

All Focus news of the innovation-report >>>

Anzeige

Anzeige

Event News

Experts from industry and academia discuss the future mobile telecommunications standard 5G

23.09.2016 | Event News

ICPE in Graz for the seventh time

20.09.2016 | Event News

Using mathematical models to understand our brain

16.09.2016 | Event News

 
Latest News

Chains of nanogold – forged with atomic precision

23.09.2016 | Life Sciences

New leukemia treatment offers hope

23.09.2016 | Health and Medicine

Self-assembled nanostructures hit their target

23.09.2016 | Life Sciences

VideoLinks
B2B-VideoLinks
More VideoLinks >>>