A team of astronomers led by the University of Leicester has uncovered new evidence that suggests that X-ray detectors in space could be the first to witness new supernovae that signal the death of massive stars.
Astronomers have measured an excess of X-ray radiation in the first few minutes of collapsing massive stars, which may be the signature of the supernova shock wave first escaping from the star.
The findings have come as a surprise to Dr Rhaana Starling, of the University of Leicester Department of Physics and Astronomy whose research is published in the Monthly Notices of the Royal Astronomical Society, published by Oxford University Press.
Dr Starling said: "The most massive stars can be tens to a hundred times larger than the Sun. When one of these giants runs out of hydrogen gas it collapses catastrophically and explodes as a supernova, blowing off its outer layers which enrich the Universe. But this is no ordinary supernova; in the explosion narrowly confined streams of material are forced out of the poles of the star at almost the speed of light. These so-called relativistic jets give rise to brief flashes of energetic gamma-radiation called gamma-ray bursts, which are picked up by monitoring instruments in Space, that in turn alert astronomers."
Gamma-ray bursts are known to arise in stellar deaths because coincident supernovae are seen with ground-based optical telescopes about ten to twenty days after the high energy flash. The true moment of birth of a supernova, when the star's surface reacts to the core collapse, often termed the supernova shock breakout, is missed. Only the most energetic supernovae go hand-in-hand with gamma-ray bursts, but for this sub-class it may be possible to identify X-ray emission signatures of the supernova in its infancy. If the supernova could be detected earlier, by using the X-ray early warning system, astronomers could monitor the event as it happens and pinpoint the drivers behind one of the most violent events in our Universe.
The X-ray detectors being used for this research, built partly in the UK at the University of Leicester, are on the X-Ray Telescope on-board the Swift satellite. Swift is named after the bird because, like its namesake, it is able to swiftly turn around to catch a gamma-ray burst in action. Data from Swift of a number of gamma-ray bursts with visible supernovae have shown an excess in X-rays received compared with expectations. This excess is thermal emission, also known as blackbody radiation.
Dr Starling added: "We were surprised to find thermal X-rays coming from a gamma-ray burst, and even more surprising is that all confirmed cases so far are those with a secure supernova identification from optical data. This phenomenon is only seen during the first thousand seconds of an event, and it is challenging to distinguish it from X-ray emission solely from the gamma-ray burst jet. That is why astronomers have not routinely observed this before, and only a small subset of the 700+ bursts we detect with Swift show it."
"It all hangs on the positive identification of the extra X-ray radiation as directly emerging from the supernova shock front, rather than from the relativistic jets or central black hole. If this radiation turns out to be from the central black-hole-powered engine of the gamma-ray burst instead, it will still be a very illuminating result for gamma-ray burst physics, but the strong association with supernovae is tantalising".
The team, comprising scientists from the UK, Ireland, USA and Denmark, plan to extend their searches, and make more quantitative comparisons with theoretical models both for stellar collapse and the dynamics of fast jet-flows.
Astronomers will continue to view supernovae at their visible-light peak, when they are already tens of days old, but for the most energetic among them it may become possible to routinely witness the very moment they are born, through X-ray eyes.
Notes to editors- For more information contact Dr Rhaana Starling on email@example.com, 0116 2231891
Prof Julian Osborne: 0116 252 3598 or firstname.lastname@example.org
Dr. Starling's work is funded by a Royal Society Dorothy Hodgkin Fellowship.
The two published works appear in Monthly Notices of the Royal Astronomical Society, Volume 427, pages 2950-2974, led by Dr. R. Starling (University of Leicester) and Mr. M. Sparre (Dark Cosmology Centre, Niels Bohr Institute, Copenhagen, Denmark).
THE UK SWIFT SCIENCE DATA CENTRE, at the University of Leicester, provides an archive of all Swift data, with open access for the wider UK astronomical community http://www.swift.ac.uk/. Funding for UK Swift activities is provided via the UK Space Agency.
ABOUT THE SWIFT OBSERVATORY
The Swift observatory was launched in November 2004 and was fully operational by January 2005. Swift carries three main instruments: the Burst Alert Telescope, the X-ray Telescope, and the Ultraviolet/ Optical Telescope. Its science and science and flight operations are controlled by Penn State from the Mission Operations Center in State College, Pennsylvania. Swift's gamma-ray detector, the Burst Alert Telescope, provides the rapid initial location and was built primarily by the NASA Goddard Space Flight Center in Greenbelt, Maryland, and Los Alamos National Laboratory in New Mexico and constructed at GSFC. Swift's X-Ray Telescope and UV/Optical Telescope were developed and built by international teams led by Penn State and drew heavily on each institution's experience with previous space missions. The X-ray Telescope resulted from Penn State's collaboration with the University of Leicester in the United Kingdom and the Brera Astronomical Observatory in Italy. The Ultraviolet/ Optical Telescope resulted from Penn State's collaboration with the Mullard Space Science Laboratory of the University College London. These three telescopes give Swift the ability to do almost immediate follow-up observations of most gamma-ray bursts because Swift can rotate so quickly to point toward the source of the gamma-ray signal. The spacecraft was built by General Dynamics. In the UK Swift is funded by the UK Space Agency.
The Royal Society is the UK's national academy of science. Founded in 1660, the Society has three roles, as a provider of independent scientific advice, as a learned Society, and as a funding agency. Our expertise is embodied in the Fellowship, which is made up of the finest scientists from the UK and beyond. For further information on the Royal Society please visit royalsociety.org. Follow the Royal Society on Twitter at http://twitter.com/royalsociety or on Facebook at http://www.facebook.com/theroyalsociety .
The Royal Astronomical Society (RAS, www.ras.org.uk), founded in 1820, encourages and promotes the study of astronomy, solar-system science, geophysics and closely related branches of science. The RAS organizes scientific meetings, publishes international research and review journals, recognizes outstanding achievements by the award of medals and prizes, maintains an extensive library, supports education through grants and outreach activities and represents UK astronomy nationally and internationally. Its more than 3500 members (Fellows), a third based overseas, include scientific researchers in universities, observatories and laboratories as well as historians of astronomy and others.
Follow the RAS on Twitter via @royalastrosoc
Dr. Rhaana Starling | EurekAlert!
Australian technology installed on world’s largest single-dish radio telescope
26.09.2016 | International Centre for Radio Astronomy Research (ICRAR)
How to merge two black holes in a simple way
26.09.2016 | Plataforma SINC
The Fraunhofer Institute for Organic Electronics, Electron Beam and Plasma Technology FEP has been developing various applications for OLED microdisplays based on organic semiconductors. By integrating the capabilities of an image sensor directly into the microdisplay, eye movements can be recorded by the smart glasses and utilized for guidance and control functions, as one example. The new design will be debuted at Augmented World Expo Europe (AWE) in Berlin at Booth B25, October 18th – 19th.
“Augmented-reality” and “wearables” have become terms we encounter almost daily. Both can make daily life a little simpler and provide valuable assistance for...
With the help of artificial intelligence, chemists from the University of Basel in Switzerland have computed the characteristics of about two million crystals made up of four chemical elements. The researchers were able to identify 90 previously unknown thermodynamically stable crystals that can be regarded as new materials. They report on their findings in the scientific journal Physical Review Letters.
Elpasolite is a glassy, transparent, shiny and soft mineral with a cubic crystal structure. First discovered in El Paso County (Colorado, USA), it can also be...
For the first time, Fraunhofer IKTS shows additively manufactured hardmetal tools at WorldPM 2016 in Hamburg. Mechanical, chemical as well as a high heat resistance and extreme hardness are required from tools that are used in mechanical and automotive engineering or in plastics and building materials industry. Researchers at the Fraunhofer Institute for Ceramic Technologies and Systems IKTS in Dresden managed the production of complex hardmetal tools via 3D printing in a quality that are in no way inferior to conventionally produced high-performance tools.
Fraunhofer IKTS counts decades of proven expertise in the development of hardmetals. To date, reliable cutting, drilling, pressing and stamping tools made of...
At AKL’16, the International Laser Technology Congress held in May this year, interest in the topic of process control was greater than expected. Appropriately, the event was also used to launch the Industry Working Group for Process Control in Laser Material Processing. The group provides a forum for representatives from industry and research to initiate pre-competitive projects and discuss issues such as standards, potential cost savings and feasibility.
In the age of industry 4.0, laser technology is firmly established within manufacturing. A wide variety of laser techniques – from USP ablation and additive...
Every three years, the plastics industry gathers at K, the international trade fair for plastics and rubber in Düsseldorf. The Fraunhofer Institute for Laser Technology ILT will also be attending again and presenting many innovative technologies, such as for joining plastics and metals using ultrashort pulse lasers. From October 19 to 26, you can find the Fraunhofer ILT at the joint Fraunhofer booth SC01 in Hall 7.
K is the world’s largest trade fair for the plastics and rubber industry. As in previous years, the organizers are expecting 3,000 exhibitors and more than...
23.09.2016 | Event News
20.09.2016 | Event News
16.09.2016 | Event News
26.09.2016 | Materials Sciences
26.09.2016 | Materials Sciences
26.09.2016 | Materials Sciences