Home Reports Information Technology Content

Software corrects chip errors early

next article

10.05.2004

Microchip miniaturization is making quality control-related measurement of features during the production process increasingly difficult. New National Institute of Standards and Technology (NIST) software and research results* should help manufacturers reduce errors in measuring microchip features which today measure less than 37 nanometers (about 1.5 millionths of an inch) in width and are expected to shrink to 25 nanometers (about 1 millionth of an inch) by 2007.

Currently, most semiconductor manufacturers use scanning electron microscopes (SEMs) to measure circuitry lines when the chip is first being patterned. Circuit dimensions are formed when ultraviolet light is shined on a thin film of polymer laid over silicon. Exposed areas harden, allowing unexposed areas to be chemically etched into tiny troughs for laying down circuit lines. Errors caught before etching may be correctable, while those caught later may result in scrapping the wafer and loss of a sizeable investment.

The NIST software equips the SEMs with a "model library" of possible line measurements. Technicians can use the enhanced SEMs to match measured images with library images in order to more accurately determine the shapes and sizes of features. Using the new software can cut measurement errors from tens of nanometers down to a few nanometers. The new method also is more reliable. There is about three times less variation among repeated measurements of the same circuit feature using the software than with the current most commonly used method.


NIST and International SEMATECH, a consortium of leading semiconductor manufacturers that represent about half the world’s semiconductor production, funded the "model library" work.

John Blair | Source: EurekAlert!
Further information: www.nist.gov/

next article