Appliance for monitoring of etching activation

A novel appliance for monitoring of wet chemical etch activation was developed at Saarland University. A desired final point of the etch activation (etch stop) can be determined by continual measurement during the wet chemical structure activation. The method is suitable for any plane-parallel substrates which are optically transparent in at least one partition of the spectrum. In particular, the following substrates are of great interest: Si, GaAs, SiC, GaN, Ge, silicon and other III-IV semiconductors.

Further Information: PDF

Universität des Saarlandes Wissens- und Technologietransfer GmbH PatentVerwertungsAgentur der saarländischen Hochschulen
Phone: +49 (0)681/9386340

Contact
Dipl.-Kfm. Axel Koch MBA

Media Contact

info@technologieallianz.de TechnologieAllianz e.V.

Alle Nachrichten aus der Kategorie: Technology Offerings

Zurück zur Startseite

Kommentare (0)

Schreib Kommentar

Neueste Beiträge

2020 Arctic sea ice minimum at second lowest on record

NASA and the National Snow and Ice Data Center (NSIDC) at the University of Colorado Boulder shows that the 2020 minimum extent, which was likely reached on Sept. 15, measured…

Dresden physicists develop printable organic transistors

Scientists at the Institute of Applied Physics at TU Dresden have come a step closer to the vision of a broad application of flexible, printable electronics. The team around Dr…

Researchers discover a mechanism that causes cell nuclei to grow

By far the most important process in cell development is how cells divide and then enlarge in order to multiply. A research team headed by Freiburg medical scientist Prof. Dr….

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close