Plastic recyclates produced from waste packaging have to meet high sensory requirements in order to be used for new products. Plastic recyclates often have off-odors, some of which have not hitherto been identified. The Fraunhofer Institute for Process Engineering and Packaging IVV has analyzed the sensory properties of post-consumer shopping bags made of low density polyethylene (LDPE) and originating from different collection systems. More than 60 odorous substances were identified using combined chemo-analytical methods. The information gained provides a targeted strategy for avoiding off-odors.
The results of this collaborative study with the Chair of Aroma and Smell Research at the Friedrich-Alexander-Universität Erlangen-Nürnberg (FAU) and the University of Alicante have now been published*.
In order to meet the targets of the new EU Packaging and Packaging Waste Directive concerning the recycling of packaging waste, new markets for recyclates produced from waste plastic packaging must be found.
Recyclates produced from waste plastic packaging must have no off-odors if they are to be used as secondary raw materials for the manufacture of high-quality consumer products.
Indeed, the off-odors in plastic recyclates prevent a closed cycle for the recycling of plastic packaging materials. Currently, there is a particularly high reusage rate for recyclates produced from polyethylene terephthalate (PET) bottles.
LDPE packaging waste in focus
The Sensory Analytics department at the Fraunhofer IVV characterizes and optimizes plastics and recyclates. The odorants in HDPE waste and the recyclates produced from packaging from bodycare products and detergents have already been analyzed.
Low density polyethylene (LDPE) is one of the most commonly used plastics. It is widely used for packaging materials such as plastic shopping bags. Via various collection systems these bags end up as packaging waste. Part of the current study on post-consumer LDPE shopping bags concerned the effect of the collection strategy on the sensory impairment of the waste.
Identification of odorants - the key step
Identification of the substances causing off-odors is essential in order to be able to take measures for odor optimization. Most of the odorants identified in the study are typical metabolites of microorganisms. Many of these metabolites had a cheese-like or feceslike odor.
The odorants included carboxylic acids and sulfur-containing and nitrogencontaining components. The chemical structures of the odorants gave key insight into their origin. Using this information, the pathways into the packaging waste and via the recycling process into the recyclate were identified.
Depending on which process step cannot remove an odorant or even results in a new odorant, targeted measures can be taken to reduce odorants or avoid the formation of new odorants.
Odorant reduction via separate collection in the yellow bag
The study showed that the way the packaging waste is collected has a large bearing on the odor quality of plastic shopping bags. There are significant benefits by separate collection in the yellow bag. Waste collected in this way had a significantly lower overall odor.
In contrast, the waste fraction collected in the general household waste had more intense cheesy-like, sulfur-like, and feces-like odors. The higher organic fraction in the general waste favors the formation of these microbial degradation products.
It was also demonstrated that the post-consumer LDPE shopping bags from the separate collection that were washed at 60 degrees had fewer odorants and a reduced overall odor than the unwashed bags.
Methods for odor identification in plastic waste
The Fraunhofer IVV scientists used sensory analytics to identify the odors. Sensory evaluation of the sample materials was first undertaken by a trained sensory panel. The odorants were then identified using chemo-analytical methods such as gas chromatography - olfactometry and with two-dimensional coupling with mass spectrometry.
This enabled the chemical structures to be determined and also possible formation pathways and sources of the odorants to be identified. These key findings can now be used to develop customized solutions for optimization of the odor of plastic recyclates, starting at the waste collection stage.
Dr. Philipp Denk
Phone: +49 8161 491-318
Dr. Philipp Denk
Phone: +49 8161 491-318
Dr. Susanne Langer | idw - Informationsdienst Wissenschaft
Road access for all would be costly, but not so much for the climate
10.07.2020 | Potsdam-Institut für Klimafolgenforschung
Innovative grilling technique improves air quality
01.07.2020 | Fraunhofer Institute for Building Physics IBP
Biochemists at Martin Luther University Halle-Wittenberg (MLU) have used a standard electron cryo-microscope to achieve surprisingly good images that are on par with those taken by far more sophisticated equipment. They have succeeded in determining the structure of ferritin almost at the atomic level. Their results were published in the journal "PLOS ONE".
Electron cryo-microscopy has become increasingly important in recent years, especially in shedding light on protein structures. The developers of the new...
New insight into the spin behavior in an exotic state of matter puts us closer to next-generation spintronic devices
Aside from the deep understanding of the natural world that quantum physics theory offers, scientists worldwide are working tirelessly to bring forth a...
Kiel physics team observed extremely fast electronic changes in real time in a special material class
In physics, they are currently the subject of intensive research; in electronics, they could enable completely new functions. So-called topological materials...
Solar cells based on perovskite compounds could soon make electricity generation from sunlight even more efficient and cheaper. The laboratory efficiency of these perovskite solar cells already exceeds that of the well-known silicon solar cells. An international team led by Stefan Weber from the Max Planck Institute for Polymer Research (MPI-P) in Mainz has found microscopic structures in perovskite crystals that can guide the charge transport in the solar cell. Clever alignment of these "electron highways" could make perovskite solar cells even more powerful.
Solar cells convert sunlight into electricity. During this process, the electrons of the material inside the cell absorb the energy of the light....
Empa researchers have succeeded in applying aerogels to microelectronics: Aerogels based on cellulose nanofibers can effectively shield electromagnetic radiation over a wide frequency range – and they are unrivalled in terms of weight.
Electric motors and electronic devices generate electromagnetic fields that sometimes have to be shielded in order not to affect neighboring electronic...
07.07.2020 | Event News
02.07.2020 | Event News
19.05.2020 | Event News
13.07.2020 | Physics and Astronomy
13.07.2020 | Life Sciences
13.07.2020 | Life Sciences