Hispaniola, the Caribbean island containing Haiti and the Dominican Republic, is located directly within the hurricane belt, and was pummeled by five tropical cyclones last year: Fay, Gustav, Hanna, Ike, and low over the Dominican Republic on Sept. 24 what would become Kyle after moving north. More than 800 people were reported dead or missing from these storms.
Haiti occupies the western third of Hispaniola, while the Dominican Republic covers the eastern two-thirds. Hispaniola is the second-largest and most populated island of the Antilles. It's located between Cuba to its west, and Puerto Rico to its east.
Hispaniola, famous as Columbus' first stop in the "New World" in 1492, has often been the target of Atlantic hurricanes. In 1979 Hurricane David claimed more than a thousand lives. On this mountainous island, landslides and flooding are usually the major causes of destruction. "Located right in the center of 'hurricane alley,' Hispaniola has a long and brutal history of hurricane destruction," notes climatologist Bill Patzert, Climatologist at NASA's Jet Propulsion Laboratory, Pasadena, Calif. "Haiti, one of the poorest countries in the Western Hemisphere, suffers from severe environmental degradation which makes hurricane landfalls especially damaging and deadly," Patzert added.
NASA satellites tracked and recorded many aspects of the tropical cyclones that hit Hispaniola. Satellites including: Aqua, CloudSat, Geostationary Operational Environmental Satellites (GOES), Landsat, QuikScat, Terra and the Tropical Rainfall Measuring Mission (TRMM).
Lake Enriqullo, located in the southwestern corner of the Dominican Republic, increased in size from all of the rainfall from the 2008 tropical cyclones. Two satellite images captured by the Landsat satellite show the lake's increase in size. Landsat is a joint NASA / U.S. Geological Survey series of Earth-observing satellites that's been in operation since 1972. The image above was created by comparing a Landsat 7 image from August 2, 2007 with an image from August 20, 2008. The red area shows where the lake has expanded. The comparison reveals that the lake has increased in size, especially along its eastern- and westernmost edges, and the reduced surface area of Lake Enriqullo's central island indicates greater water volume.
Fay was an unusual tropical cyclone because it had eight landfalls, four of them in Florida alone. Fay's torrential rainfall caused extensive floods across the Dominican Republic, Haiti, Cuba, and Florida. After a landfall in Hispaniola on Aug. 15, and despite its course over the mountainous southern portion of the Dominican Republic and Haiti, Fay remained a tropical storm. According to the National Hurricane Center's final report on Fay, "Water levels in reservoirs had been running low and water restrictions were about to be implemented. Fay’s motion across the northern Caribbean Sea produced prolonged heavy rain events in Hispaniola and Cuba. News reports indicate that floods devastated the Haitian island of Gonavé. The saturated ground conditions created by the heavy rains from Fay set the stage for an even greater flood devastation and resultant loss of life caused by heavy rains produced by Hurricanes Gustav, Hanna, and Ike that traversed Haiti during the ensuing two weeks. In the Dominican Republic, rainfall totals exceeding 7-10 inches occurred primarily over the southern half of the country."
Hurricane Gustav crossed onto Haiti's southern peninsula on Aug. 26, 2008 as a Category 1 storm with 70 mph winds that killed at least one person. Gustav's rains caused a landslide near the Haitian town of Brazillienne, and floodwaters split the town of Jacmel in half where it made landfall. According to the National Hurricane Center's final storm report, "Heavy rainfall and widespread freshwater flooding occurred along the path of Gustav. Camp Perrin, Haiti reported a storm total rainfall of 10.75 inches, while Baharona, Dominican Republic reported a storm total rainfall of 9.71 inches." Gustav had formed only one day before about 260 miles southeast of Port-au-Prince, Haiti.
Just one week later on Sept. 3, Tropical Storm Hanna dumped very heavy rainfall totals of much of Hispaniola and Puerto Rico as its center passed just north and northwest of those islands. The maximum rainfall reported in the Dominican Republic was 14.17 inches at the town of Oviedo. Haitian residents were forced onto rooftops to avoid serious flooding. Haiti's deforested hillsides were the victim of mudslides from torrential rains. Hanna had killed 21 people and cut off the city of Gonaives with flood waters.
Hurricane Ike bore down on Cuba after roaring across low-lying islands on Sept. 7 tearing apart houses, wiping out crops and worsening floods in Haiti that had already killed more than 300 people. Heavy rains also pelted the Dominican Republic, Haiti's neighbor on the island of Hispaniola, where about 4,000 people were evacuated from northern coastal towns.
According to the National Hurricane Center's final report on Ike, "Parts of Hispaniola, especially Haiti, were devastated by widespread flooding and mud slides from four consecutive impacts by Tropical Storm Fay and Hurricanes Gustav, Hanna, and Ike. Overall, 793 people died in Haiti from the four storms, with another 300 people reported missing. It is estimated that 74 deaths are directly attributable to the effects of Ike. Ike exacerbated the humanitarian disaster in Haiti, wiping out the food supply, shelter, and transportation networks across the nation. Two deaths have been reported in the Dominican Republic."
NASA's Tropical Rainfall Measuring Mission (TRMM) satellite has been measuring rainfall from space ever since it was launched in November 1997. The TRMM analysis above shows a complete history of rainfall with Hurricane Ike from when it was named on Sept. 1, 2008, through Sept. 15, 2008.
Only rainfall data attributed to Hurricane Ike were used in the TRMM calibrated rainfall analysis. Merged rainfall Data (3B42) from TRMM, other NASA satellites, U.S. Department of Defense satellites, National Oceanic and Atmospheric Administration polar-orbiting satellites, and geostationary satellites were used in the analysis.
Ike caused flooding almost every time it was near or over land. The analysis shows that Hispaniola received between 100 and 200 mm (between 4 and 8 inches) of rainfall. Most of Cuba received more than 150 mm (~6 inches) with some areas showing totals averaging above 250 mm (~10 inches), and areas of southeast Texas received heavy rainfall—above 200 mm (close to 8 inches). Ike moved very quickly toward the northeast after leaving Texas but was still responsible for flooding in Missouri, Illinois and Indiana.
The low pressure system that ambled its way slowly over the Dominican Republic on Sept. 23–24 became Kyle after leaving Hispaniola. According to the National Hurricane Center report on Kyle, "The low took two days to cross the island, producing disorganized thunderstorms and a large area of squalls within a convective band over the adjacent Caribbean Sea." It became a tropical depression on Sept. 25, 100 miles north of the Dominican Republic and later became Kyle. Over Hispaniola, the low brought heavy rains, flash floods and mud slides.
While residents of Hispaniola are hoping for a calmer hurricane season in 2009, NASA satellites will be keeping a close eye on the Atlantic Ocean basin.
Rob Gutro | EurekAlert!
Further reports about: > Atlantic hurricanes > Cuba > Cyclone > Geostationary Operational Environmental Satellites > Haiti > Hispaniola > Hurricane > Hurricane Ike > NASA > NASA satellites > QuikScat > TRMM > Tropical Rainfall Measuring Mission > Western Hemisphere > flood devastation > history of hurricane destruction > hurricane landfalls > rainfall > satellites > tropical cyclone > tropical diseases
Algorithm provides early warning system for tracking groundwater contamination
14.08.2018 | DOE/Lawrence Berkeley National Laboratory
Artificial Glaciers in Response to Climate Change?
10.08.2018 | Universität Heidelberg
Scientists develop first tool to use machine learning methods to compute flow around interactively designable 3D objects. Tool will be presented at this year’s prestigious SIGGRAPH conference.
When engineers or designers want to test the aerodynamic properties of the newly designed shape of a car, airplane, or other object, they would normally model...
Researchers from TU Graz and their industry partners have unveiled a world first: the prototype of a robot-controlled, high-speed combined charging system (CCS) for electric vehicles that enables series charging of cars in various parking positions.
Global demand for electric vehicles is forecast to rise sharply: by 2025, the number of new vehicle registrations is expected to reach 25 million per year....
Proteins must be folded correctly to fulfill their molecular functions in cells. Molecular assistants called chaperones help proteins exploit their inbuilt folding potential and reach the correct three-dimensional structure. Researchers at the Max Planck Institute of Biochemistry (MPIB) have demonstrated that actin, the most abundant protein in higher developed cells, does not have the inbuilt potential to fold and instead requires special assistance to fold into its active state. The chaperone TRiC uses a previously undescribed mechanism to perform actin folding. The study was recently published in the journal Cell.
Actin is the most abundant protein in highly developed cells and has diverse functions in processes like cell stabilization, cell division and muscle...
Scientists have discovered that the electrical resistance of a copper-oxide compound depends on the magnetic field in a very unusual way -- a finding that could help direct the search for materials that can perfectly conduct electricity at room temperatur
What happens when really powerful magnets--capable of producing magnetic fields nearly two million times stronger than Earth's--are applied to materials that...
The quality of materials often depends on the manufacturing process. In casting and welding, for example, the rate at which melts solidify and the resulting microstructure of the alloy is important. With metallic foams as well, it depends on exactly how the foaming process takes place. To understand these processes fully requires fast sensing capability. The fastest 3D tomographic images to date have now been achieved at the BESSY II X-ray source operated by the Helmholtz-Zentrum Berlin.
Dr. Francisco Garcia-Moreno and his team have designed a turntable that rotates ultra-stably about its axis at a constant rotational speed. This really depends...
08.08.2018 | Event News
27.07.2018 | Event News
25.07.2018 | Event News
14.08.2018 | Information Technology
14.08.2018 | Life Sciences
14.08.2018 | Life Sciences