New setup for force sensors
Normally the measuring device of a force sensor is made of one piece of high-quality spring steel. Afterwards strain gauges are pasted on the device or the device is coated with a thin film which will be structured photolithographically. An essential problem of the measuring de-vice is its high volume. Therefore it is very complex and expensive to use thin film technology, because it is very diffi-cult to place such devices in a coating plant.
At the Saarland University of Applied Sciences a new force sensor was developed by Prof. Schultes which can be produced in a simple and cheap way.
Further Information: PDF
Universität des Saarlandes Wissens- und Technologietransfer GmbH PatentVerwertungsAgentur der saarländischen Hochschulen
Phone: +49 (0)681/9386340
Contact
Dipl.-Kfm. Axel Koch MBA
Media Contact
All latest news from the category: Technology Offerings
Newest articles
Properties of new materials for microchips
… can now be measured well. Reseachers of Delft University of Technology demonstrated measuring performance properties of ultrathin silicon membranes. Making ever smaller and more powerful chips requires new ultrathin…
Floating solar’s potential
… to support sustainable development by addressing climate, water, and energy goals holistically. A new study published this week in Nature Energy raises the potential for floating solar photovoltaics (FPV)…
Skyrmions move at record speeds
… a step towards the computing of the future. An international research team led by scientists from the CNRS1 has discovered that the magnetic nanobubbles2 known as skyrmions can be…
