Lasers in a flash

Ultrafast time-resolved laser spectroscopy is a technique that uses the interaction of light with matter to study the properties of physical systems. Researchers can generate laser pulses lasting mere attoseconds—quintillionths of seconds—to examine the nuclear dynamics in different states of matter, including single atoms.

Generating isolated attosecond pulses reliably is challenging. Commonly, physicists use few-cycle laser pulses with a near infrared wavelength as a pump to temporarily ionize specific atoms, typically those of a noble gas. When an electron re-collides with a nucleus from which it has been pulled away, it emits light with a much higher frequency than the one in the pump laser. This so-called ‘high-order harmonic generation’ usually in the extreme ultraviolet region can create an attosecond pulse.

Eiji Takahashi and his colleagues at the RIKEN Advanced Science Institute in Wako, in collaboration with scientists at the Vienna University of Technology, Austria, have now reported a way to easily produce isolated attosecond pulses, which surpasses all previous attempts for simplicity and reliability1.

A number of research groups have recently generated isolated laser pulses as short as 80 attoseconds. However, their energy is still too low be used in practice, since the energy of the pump pulses is limited. High pump energy would induce high gas ionization such that the atoms hit by the pump pulses would be highly ionized, but this would prevent the whole process of re-collision. In addition, to guarantee reliable production of isolated attosecond pulses, the phase of the carrier envelope wave connected to the pump pulse needs to be stabilized, which requires an expensive and complicated process.

To circumvent these limitations, Takahashi and colleagues used a two-color laser field: a pump laser with an 800-nanometer wavelength superimposed on one of 1,300 nanometers. The combination of the two lasers allowed the generation of a higher harmonic spectrum without needing to stabilize the carrier envelope phase.

Crucially, they used conventional lasers that are readily available and inexpensive. “This novel two-color laser scheme also enables one to markedly suppress the detrimental gas target ionization,” notes Takahashi. “Consequently, not only the most appropriate phase-matching technique, but also an energy-scaling scheme, can be applied to produce intense isolated attosecond pulses.”

Takahashi also says that this method has the potential to produce isolated, attosecond, extreme-ultraviolet x-ray pulses with microjoule energy from a table-top system. He believes this would open the door to the realm of strongly nonlinear attosecond science.

The corresponding author for this highlight is based at the Extreme Photonics Research Group, RIKEN Advanced Science Institute.

1. Takahashi, E.J., Lan, P., Mücke, O.D., Nabekawa, Y. & Midorikawa, K. Infrared two-color multicycle laser-field synthesis for generating an intense attosecond pulse. Physical Review Letters 104, 233901 (2010).

Media Contact

gro-pr Research asia research news

All latest news from the category: Process Engineering

This special field revolves around processes for modifying material properties (milling, cooling), composition (filtration, distillation) and type (oxidation, hydration).

Valuable information is available on a broad range of technologies including material separation, laser processes, measuring techniques and robot engineering in addition to testing methods and coating and materials analysis processes.

Back to home

Comments (0)

Write a comment

Newest articles

Silicon Carbide Innovation Alliance to drive industrial-scale semiconductor work

Known for its ability to withstand extreme environments and high voltages, silicon carbide (SiC) is a semiconducting material made up of silicon and carbon atoms arranged into crystals that is…

New SPECT/CT technique shows impressive biomarker identification

…offers increased access for prostate cancer patients. A novel SPECT/CT acquisition method can accurately detect radiopharmaceutical biodistribution in a convenient manner for prostate cancer patients, opening the door for more…

How 3D printers can give robots a soft touch

Soft skin coverings and touch sensors have emerged as a promising feature for robots that are both safer and more intuitive for human interaction, but they are expensive and difficult…

Partners & Sponsors