Most electronic data is stored on magnetic hard drives that spin at many thousands of revolutions per minute. To keep pace with ever-growing storage demand, however, achieving greater storage capacities by simply increasing the size of disks is infeasible.
The required spinning speed would put immense physical strain on the components, particularly on the writing ‘head’ — a small needle-like object used to write data at particular points on the disk (see image).
An alternative technology, heat-assisted magnetic recording (HAMR), is now a significant step closer to commercial realization, thanks to the efforts of Baoxi Xu and his co-workers at the A*STAR Data Storage Institute, Singapore1. In a system using HAMR, laser light is emitted from a diode on the write head to locally heat the disk during data writing. This technique has the potential to increase a standard disk’s recording density by as much as two orders of magnitude. However, the additional heat can cause components such as the write head to destabilize and fall out of alignment.
By studying the temperature increase of the head, the thermal effects on the disk and the thermal response of the lubricant in HAMR, Xu and his co-workers discovered how to maximize the recording density of the medium. They began by establishing the three major heat sources present in the device: the laser diode, the optical transducer, which concentrates the incident light into a nanometer-sized spot, and the write pole, which performs the physical recording.
They found that the temperature of the transducer depends on both its size and distance from the write pole — both of which can be easily controlled in a commercial device. They also found that the temperature rise in the HAMR head does not significantly inhibit the performance of the laser diode, which is important.
Xu and his team’s results showed that the recording density of the medium can be maximized by reducing the number of layers through which the heat energy must pass before it can dissipate. This will be of prime importance for achieving the required high-density data storage goals of commercial devices. This study therefore represents an important breakthrough in our understanding of HAMR, and will be essential in bringing this technology closer to commercial fruition.
“Our work indicates the seriousness of the problems in the HAMR head, which gives a reference for HAMR design, and also provides a direction for improving thermal structures for high-density HAMR recording,” Xu says.
The A*STAR-affiliated researchers contributing to this research are from the Data Storage Institute
Xu, B. X., Liu, Z. J., Ji, R., Toh, Y. T., Hu, J. F. et al. Thermal issues and their effects on heat-assisted magnetic recording system (invited). Journal of Applied Physics 111, 07B701 (2012).
More articles from Physics and Astronomy:
NASA's SDO Shows the Sun's Rainbow of Wavelengths
18.12.2013 | NASA's Goddard Space Flight Center
Clot-Busters, Caught on Tape
17.12.2013 | American Institute of Physics (AIP)
A 12-year study of massive stars has reaffirmed that our Galaxy has four spiral arms, following years of debate sparked by images taken by NASA's Spitzer Space Telescope that only showed two arms.
The new research, which is published online today [17 December] in the Monthly Notices of the Royal Astronomical Society, is part of the RMS Survey, which was launched by academics at the University of Leeds.
Astronomers cannot see what our Galaxy, which is called the Milky Way, looks like because we ...
In collaboration with the University of Basel, an international team of researchers has observed a strong energy loss caused by frictional effects in the vicinity of charge density waves.
This may have practical significance in the control of nanoscale friction. The results have been published in the scientific journal Nature Materials.
Friction is often seen as an adverse phenomenon that leads to wear and causes energy loss. Conversely, however, too little friction can be a disadvantage as well – ...
A new type of transistor that could make possible fast and low-power computing devices for energy-constrained applications such as smart sensor networks, implantable medical electronics and ultra-mobile computing is feasible, according to Penn State researchers.
Called a near broken-gap tunnel field effect transistor (TFET), the new device uses the quantum mechanical tunneling of electrons through an ultrathin energy barrier to provide high current at low voltage.
Penn State, the National Institute of Standards and Technology and IQE, a specialty wafer manufacturer, jointly presented their findings at ...
The team of Johannes Zuber at the IMP in Vienna, Austria, managed to overcome remaining key limitations of RNA interference (RNAi) - a unique method to specifically shut off genes.
By using an optimized design, the scientists were able to inhibit genes with greatly enhanced efficiency and accuracy. The new method facilitates the search for drug targets and improves the interpretation of experimental results.
The IMP will make this „RNAi toolkit“ available to researchers. Results of the study are published in ...
Research The dangerous parasite Schistosoma mansoni that causes snail fever in humans could become significantly less common in the future a new international study led by researchers from the University of Copenhagen predicts.
The results are surprising because they contradict the general assumption that climate change leads to greater geographical spread of diseases. The explanation is that the parasite’s host snails stand to lose suitable habitat due to climate change.
“Our research shows that the expected effects of climate change will lead ...
18.12.2013 | Life Sciences
18.12.2013 | Medical Engineering
18.12.2013 | Studies and Analyses
11.12.2013 | Event News
10.12.2013 | Event News
05.12.2013 | Event News