As a consequence of the new launch date, the Gravity field and steady-state Ocean Circulation Explorer (GOCE) satellite is currently undergoing final flight reconfiguration at ESA-ESTEC in the Netherlands.
Shipment to the Plesetsk launch site in northern Russia will take place in July - from where the sleek five-metre long GOCE spacecraft will be carried into its unusually low orbit on a modified SS-19 Russian Intercontinental Ballistic Missile (ICBM) launcher. The adaptation of the SS-19, called 'Rockot', uses the two original lower stages of the ICBM in conjunction with an upper-stage called Breeze-KM for commercial payloads.Up until early March this year, GOCE was well on its way to being launched at the end of May. However, as a result of the failure on
15 March of a Proton Breeze-M upper-stage, all launches using Breeze were suspended pending investigations by the Russian State Commission. Although GOCE's Breeze-KM upper-stage is different to the larger Proton Breeze-M, they do share some common elements. The investigations have led to the conclusion that it is safe to use the Breeze-KM as is, resulting in the Russian State Commission clearing GOCE for launch.
Since August last year, the high-tech GOCE spacecraft has been undergoing extensive testing at ESA's test facilities in the Netherlands. The programme included a wide range of qualification tests to ensure that the satellite could withstand the rigours of launch as well as the harsh environment of space. One such series of tests was carried out in the Large Space Simulator where, under vacuum, the extreme heat of the Sun is simulated by lamps and mirrors - subjecting the satellite to 1400 W of power over each square metre of the side of the satellite that faces the Sun.
As well as being designed to fly in an orbit as low as is technically feasible to retrieve the strongest possible gravity signal, the sleek arrow-shaped satellite is ultra-stable to ensure that measurements taken are of true gravity and not influenced by any movement of the satellite. GOCE, therefore, has none of the moving parts often seen on other spacecraft. Since GOCE is designed to orbit the Earth with one side always facing the Sun, one side only is equipped with solar panels.
Due to its low altitude and inclination, once a year the GOCE satellite will experience an eclipse period of 135 days with one eclipse of up to 28 minutes per orbit. A peculiarity of orbital dynamics is that one is free to choose the eclipse period to fall either between October and February or, between April and August by launching either in the morning or in the evening of the launch day.
Now launching in September, it is best to have the eclipses in the April to August time frame. The May launch would still have gone for the eclipse season in winter. The difference in the two configurations is that, as seen from the Sun, the satellite either flies clock- or anti-clockwise around the Earth. This has impact on the satellite configuration and some units have to be moved from one side of the satellite to the other. Thanks to the flexibility of the satellite design, this is a relatively simple operation. Therefore, modifications to accommodate this new flight configuration are about to be carried out at ESA in the Netherlands. When GOCE has been reconfigured, the spacecraft will be transported by aircraft from the Netherlands to Arkhangelsk in Russia, and from there by train to the launch site in Plesetsk for final testing.
Once launched, GOCE will begin to map global variations in the gravity field with unprecedented detail and accuracy. This will result in a unique model of the geoid, which is the surface of equal gravitational potential defined by the gravity field – crucial for deriving accurate measurements of ocean circulation and sea-level change, both of which are affected by climate change. GOCE-derived data is also much needed to understand more about processes occurring inside the Earth and for use in practical applications such as surveying and levelling.
Danilo Muzi | alfa
Gamma rays will reach beyond the limits of light
23.10.2017 | Chalmers University of Technology
Creation of coherent states in molecules by incoherent electrons
23.10.2017 | Tata Institute of Fundamental Research
Salmonellae are dangerous pathogens that enter the body via contaminated food and can cause severe infections. But these bacteria are also known to target...
University of Maryland researchers contribute to historic detection of gravitational waves and light created by event
On August 17, 2017, at 12:41:04 UTC, scientists made the first direct observation of a merger between two neutron stars--the dense, collapsed cores that remain...
Seven new papers describe the first-ever detection of light from a gravitational wave source. The event, caused by two neutron stars colliding and merging together, was dubbed GW170817 because it sent ripples through space-time that reached Earth on 2017 August 17. Around the world, hundreds of excited astronomers mobilized quickly and were able to observe the event using numerous telescopes, providing a wealth of new data.
Previous detections of gravitational waves have all involved the merger of two black holes, a feat that won the 2017 Nobel Prize in Physics earlier this month....
Material defects in end products can quickly result in failures in many areas of industry, and have a massive impact on the safe use of their products. This is why, in the field of quality assurance, intelligent, nondestructive sensor systems play a key role. They allow testing components and parts in a rapid and cost-efficient manner without destroying the actual product or changing its surface. Experts from the Fraunhofer IZFP in Saarbrücken will be presenting two exhibits at the Blechexpo in Stuttgart from 7–10 November 2017 that allow fast, reliable, and automated characterization of materials and detection of defects (Hall 5, Booth 5306).
When quality testing uses time-consuming destructive test methods, it can result in enormous costs due to damaging or destroying the products. And given that...
Using a new cooling technique MPQ scientists succeed at observing collisions in a dense beam of cold and slow dipolar molecules.
How do chemical reactions proceed at extremely low temperatures? The answer requires the investigation of molecular samples that are cold, dense, and slow at...
23.10.2017 | Event News
17.10.2017 | Event News
10.10.2017 | Event News
23.10.2017 | Life Sciences
23.10.2017 | Physics and Astronomy
23.10.2017 | Health and Medicine