Imagine a battlefield medic or emergency medical technician providing first aid with a special wad of cottony glass fibers that simultaneously slows bleeding, fights bacteria (and other sources of infection), stimulates the body’s natural healing mechanisms, resists scarring, and-because it is quickly absorbed by surrounding tissue - may never have to be removed in follow-up care.
Or, imagine diabetics with hard-to-heal wounds finding a source of relief from the battle against infections and limb amputation.
Those scenarios are the hope of the developers of a revolutionary borate glass nanofiber material, which appears have sped and helped the final of healing long-term wounds in eight out of 12 venous stasis wound sufferers in a recent clinical trial held at a medical center in Rolla, Mo.
Details about the trials and the glass fiber material were published today in the May issue of the American Ceramic Society’s Bulletin magazine.
The story reports on the discovery of the fibers and on an empirical study that began late in the fall of 2010 supervised by the internal review board of the Phelps County Regional Medical Center. The trial groups originally had 13 volunteer members, but one dropped out during the early stages.
According to Peggy Taylor, the PCRMC registered nurse who administered the treatments, all of the volunteers in the trial are enthusiastic about the use of the glass fiber product, which she says “looks like cotton candy.”
“All of the participants had diabetes and several of them had wounds that had been unhealed for more than a year,” says Taylor, a specialist in wound care. “One patient had the same wound for three years. After using the glass fiber product for a few months, we were able to repair the skin in eight of the patients. Remarkably, the other four have made a lot of progress and all of their wounds should be healed soon, too.”
All of the patients suffered from problems associated with venous stasis, a condition where blood circulation in extremities is poor. As the blood pools, typically in lower legs, fluids accumulate causing unusual pressure on skin tissues. Sores and wounds can then develop when the fluid “weeps” from skin cracks, cuts or abrasions.
Because of an enzyme in the weeping fluid, the skin surrounding small venous stasis injuries can quickly erode and turn into large and deep wounds. Even small bruises can eventually develop into bone-deep openings.
The goal of the PCRMC trial was to provide an initial evaluation of the effects of the novel fibrous glass material produced by the Mo-Sci Corporation, a Rolla company already known for creating glass-based materials for medical applications.
“Bioglass” materials aren’t particularly new to the medical field, but thus far all bioglass has been formed from a silica-based glass composition, and these primarily have been used in hard-tissue regeneration, such as bone repair.
Glass scientist Steve Jung, who helped develop the new material, says he and co-developer Delbert Day had wondered whether a different type of bioactive glass material could be used for soft-tissue regeneration. “We felt from our in-vitro studies that bioactive glasses containing boron would react to body fluids much faster than silicate glasses,” says Jung, who obtained his Ph.D from Missouri University of Science and Technology, where he conducted his research with Day, a professor at the university. “We also knew that an in-vitro study of lithium borate glasses had showed it to have beneficial effects against bacteria, such as E. coli, salmonella and staphylococcus microbes.”
Lastly, Jung and Day recall they were interested in a composition that was rich in calcium. “Previously, investigators have reported that calcium is important for wound healing. It appears to assist the migration of epidermal cells and help the body regulate the healing process of open wounds,” says Jung.
Besides composition, Jung and Day thought the structure of the material may be important to consider, too, and suspected that providing a healing “scaffold” might be beneficial. “We thought it might be advantageous to have a material that could mimic the microstructure of fibrin that forms the basis of a blood clot. We reasoned that if the structure could imitate fibrin, it might trap blood platelets and allow the formation of a wound cover that could support the healing process.”
Jung and Day finally settled on a particular borate glass composition - called 13-93B3 glass - one that Mo-Sci, a company founded by Day, already knew how to form into cottony glass fibers, 300 nanometers to 5 micrometers in diameter.
After animal tests showed no adverse effects, Mo-Sci obtained a license to the material from Missouri S&T, named the borate glass material “DermaFuse,” and approached PCRMC about starting the small-scale human test.
PCRMC approved the trial in July 2010, and nurse Taylor saw her first patient one month later. Once the study was underway, the company provided Taylor with individual, foil-sealed packets containing pads made of the glass fibers. She says the material is easy to apply. “It gets kind of squished in the packs, but you can form it, pick it, make it into any kind of shape you need out of it. I used tweezers to pack the material up into all of the recesses before filling the rest of the wound. I didn’t pack it hard, but enough to fill all the crevices. Once it was in place, I covered it with a secondary covering or compression wrap.”
One thing that surprised Taylor was that the glass fibers seem to disappear over time, a phenomenon that has been observed with other bioglasses. “Does it dissolve? Does it become part of the tissue? We don’t quite know, but it is just such a neat thing to watch that process.”
Taylor acknowledges that under her care, the wounds would have probably healed without the glass material, but they would have required expensive vacuum-assisted healing systems that must be carried by patient at all times.
Besides low cost and ease of use, Taylor says the glass fibers seem to offer another stunning benefit: low scarring. “All but one of the patients in the trial were elderly and had a lot of skin discoloration, but we healed wounds that show nothing or negligible scarring,” she says.
Jung, who now works as a senior researcher for Mo-Sci, says that the next step is expanded human trials, which will be conducted in partnership with the Center for Wound Healing and Tissue Regeneration at the University of Illinois at Chicago. He says the center has agreed to begin testing the material this summer.
In the meantime, Jung says he and Day are optimistic about a new era in wound treatment. “We are really hoping the properties of these fibers can help with more extensive wounds, such as burns, and we easily foresee the day when soldiers or EMT workers carry packets of these glass fibers to provide healing protective covers that don’t have to be removed.”
The story, “Cotton candy that heals? Borate glass fibers look promising” is available online at http://americanceramicsociety.org/bulletin/2011_pdf_files/may_11/#/27/Video interviews with Peggy Taylor and Steve Jung are available online at: http://tinyurl.com/5vlsek3
Editor’s note: For high- and low-resolution photographs and captions of the borate glass fiber materials, time-sequence wound healing and TEM comparisons with natural fibrin are available, please contact Peter Wray.About ACerS
Peter Wray | EurekAlert!
A promising target for kidney fibrosis
21.04.2017 | Brigham and Women's Hospital
Stem cell transplants: activating signal paths may protect from graft-versus-host disease
20.04.2017 | Technische Universität München
More and more automobile companies are focusing on body parts made of carbon fiber reinforced plastics (CFRP). However, manufacturing and repair costs must be further reduced in order to make CFRP more economical in use. Together with the Volkswagen AG and five other partners in the project HolQueSt 3D, the Laser Zentrum Hannover e.V. (LZH) has developed laser processes for the automatic trimming, drilling and repair of three-dimensional components.
Automated manufacturing processes are the basis for ultimately establishing the series production of CFRP components. In the project HolQueSt 3D, the LZH has...
Reflecting the structure of composites found in nature and the ancient world, researchers at the University of Illinois at Urbana-Champaign have synthesized thin carbon nanotube (CNT) textiles that exhibit both high electrical conductivity and a level of toughness that is about fifty times higher than copper films, currently used in electronics.
"The structural robustness of thin metal films has significant importance for the reliable operation of smart skin and flexible electronics including...
The nearby, giant radio galaxy M87 hosts a supermassive black hole (BH) and is well-known for its bright jet dominating the spectrum over ten orders of magnitude in frequency. Due to its proximity, jet prominence, and the large black hole mass, M87 is the best laboratory for investigating the formation, acceleration, and collimation of relativistic jets. A research team led by Silke Britzen from the Max Planck Institute for Radio Astronomy in Bonn, Germany, has found strong indication for turbulent processes connecting the accretion disk and the jet of that galaxy providing insights into the longstanding problem of the origin of astrophysical jets.
Supermassive black holes form some of the most enigmatic phenomena in astrophysics. Their enormous energy output is supposed to be generated by the...
The probability to find a certain number of photons inside a laser pulse usually corresponds to a classical distribution of independent events, the so-called...
Microprocessors based on atomically thin materials hold the promise of the evolution of traditional processors as well as new applications in the field of flexible electronics. Now, a TU Wien research team led by Thomas Müller has made a breakthrough in this field as part of an ongoing research project.
Two-dimensional materials, or 2D materials for short, are extremely versatile, although – or often more precisely because – they are made up of just one or a...
20.04.2017 | Event News
18.04.2017 | Event News
03.04.2017 | Event News
25.04.2017 | Physics and Astronomy
25.04.2017 | Materials Sciences
25.04.2017 | Life Sciences