
CT scanners are equipped with one or two X-ray tubes that rotate around the patient. A detector is positioned opposite each tube. Bones and body tissue attenuate X-rays to different degrees. The detectors register the X-rays and transform them into digital signals. The results are high-resolution CT images.
The new Stellar detectors can generate images of even higher quality than was previously the case, even if lower X-ray dosages are used. As a consequence, a Stellar-equipped scanner such as the Somatom Definition Flash can, for example, make a complete scan of the heart in less than one-third of a second and still achieve a resolution of 0.30 millimeters.
What's more, the exposure to radiation is significantly reduced. Thanks to the short scanning times, patients can be examined without having to take beta blockers that lower their heart rate. Obese people can also be examined more easily as the Stellar detectors provide good images even if the X-ray signals are extremely attenuated by thick layers of fat tissue. The same applies to scans made with extremely low doses of radiation, such as those used to examine children and pregnant women.
The key to achieving such a high level of sensitivity is an all-new detector technology that almost totally eliminates the "noise" of the electronic components. The CT detector contains scintillator crystals that first convert the incoming X-rays into visible light.
Photodiodes then convert the light into an analogue electrical signal, which is subsequently digitized. The digital data is used to create cross-sectional images without any overlap. The length of the electrical connection between the analogue components influences the signal-noise ratio and thus the detector's sensitivity. It was decided to reduce the length of the cables, which are only a few centimeters long, to a minimum. To this end, in conjunction with Siemens' global research unit Corporate Technology and the microchip manufacturer AMS, Siemens Healthcare developed a chip with an integrated circuit as well as photodiodes and analogue-digital converters. The new detector is not only more sensitive than previous systems but also consumes 80 percent less energy.
Siemens is equipping all of the new CT scanners from the Somatom Definition Flash and Somatom Definition Edge series with Stellar detectors. Older Somatom Definition Flash and Somatom Definition AS scanners can be retrofitted.
Dr. Norbert Aschenbrenner | Source: Siemens InnovationNews
Further information:
www.siemens.com/innovationnews
Further Reports about: CT scan > CT scanner > Somatom > Stellar Jets > X-ray microscopy > X-ray tube > X-rays
More articles from Medical Engineering:
Varian Software Successfully Connected with Siemens Linear Accelerators
13.06.2013 | Siemens AG
Heart to Heart: Cardiac PET/MR Measures Up To PET/CT
11.06.2013 | Society of Nuclear Medicine
... two engines aircraft project “Elektro E6”.
The countdown has been started for opening the gates again for the worldwide leading aviation and space event in Le Bourget, Paris from June 17th - 23rd, 2013.
EADCO & PC-Aero will present at the Paris Air Show in Hall H4 booth F-7 their new future aircraft and innovative project: ...
Siemens scientists have developed new kinds of ceramics in which they can embed transformers.
The new development allows power supply transformers to be reduced to one fifth of their current size so that the normally separate switched-mode power supply units of light-emitting diodes can be integrated into the module's heat sink.
The new technology was developed in cooperation with industrial and research partners who ...
Cheaper clean-energy technologies could be made possible thanks to a new discovery.
Led by Raymond Schaak, a professor of chemistry at Penn State University, research team members have found that an important chemical reaction that generates hydrogen from water is effectively triggered -- or catalyzed -- by a nanoparticle composed of nickel and phosphorus, two inexpensive elements that are abundant on Earth. ...
The Fraunhofer Institute for Laser Technology ILT generated a lot of interest at the LASER World of Photonics 2013 trade fair with its numerous industrial laser technology innovations.
Its highlights included beam sources and manufacturing processes for ultrashort laser pulses as well as ways to systematically optimize machining processes using computer simulations. There was even a specialist booth at the fair dedicated to the revolutionary technological potential of digital photonic production.
Now in its fortieth year, LASER World ...
It's not reruns of "The Jetsons", but researchers working at the National Institute of Standards and Technology (NIST) have developed a new microscopy technique that uses a process similar to how an old tube television produces a picture—cathodoluminescence—to image nanoscale features.
Combining the best features of optical and scanning electron microscopy, the fast, versatile, and high-resolution technique allows scientists to view surface and subsurface features potentially as small as 10 nanometers in size.
The new microscopy technique, described in the journal AIP Advances,* uses a beam of electrons to excite a specially ...
18.06.2013 | Materials Sciences
Artificial Sweetener a Potential Treatment for Parkinson's Disease
18.06.2013 | Health and Medicine
New way to improve antibiotic production
18.06.2013 | Life Sciences
International Symposium on Morphogenesis
14.06.2013 | Event News
ESMT Annual Forum: CEOs discuss “The Future of Jobs” with international academics and policymakers
13.06.2013 | Event News
Invitation: Mathematics for Industry and Society in the French Embassy Berlin, 04. - 05.07.2013
10.06.2013 | Event News