
The Stellar Detector can transmit analog data with minimal wiring, making it possible to digitize the measured signals with virtually no interference. The wiring used in traditional detector technology generates electronic noise that can diminish the quality of the medical images from low-intensity signals.
The only way to reduce this noise would be to increase the radiation dose. Siemens has now succeeded in combining all the signal conversion electronics on a single chip. This is a critical breakthrough for enhanced CT image quality – at lower levels of radiation – and yet another demonstration of the innovative power of Siemens Healthcare and its "Agenda 2013" initiative.
The development of computed tomography (CT) is dominated by efforts to enhance the quality of the images and decrease the required doses of radiation. The detector – which, together with the x-ray tube, forms the scanner that is integrated into the ring-shaped gantry and rotates around the patient – is no less crucial. X-rays are absorbed by the body to varying degrees, depending on the type of scanned tissue. The detector measures this absorption and uses this information to create a digital signal.
Standard detector technology has very little potential for meaningful progress when it comes to reducing doses and optimizing images, however. That's because the signals have to pass through a complex wiring system several centimeters in length to reach the electronics that perform the analysis. This has a negative impact on the signal-to-electronic-noise ratio (SENR) – and ultimately on the image quality: The longer the wires, the greater the electronic noise. And the greater the electronic noise, the poorer the image quality. This is especially true at lower doses.
To reduce image noise, we had to minimize the signal wiring. The Siemens detector development team in Forchheim achieved this by combining all the analysis electronics on a single chip. The Stellar Detector is the first product to feature the newly designed electronics. The new detector can now convert the analog signals from the photo diode to digital signals with almost no interference. The converted signals can then be processed digitally with no loss. This makes it possible to produce medical images with a noticeably higher SENR than before at the same radiation dose.
"The Stellar Detector reduces image noise by 20 to 30 percent compared to conventional detectors," notes Prof. Dr. Jörg Hausleiter, director of the cardiac intensive care unit at the German Heart Centre in Munich. "This makes it possible for us to work with lower radiation in a broad spectrum of examinations – and the image quality has improved at the same time."
Combined with the Somatom Definition Flash and Somatom Definition Edge high-end CT scanners, Stellar delivers extremely detailed images with a spatial resolution as fine as 0.30 millimeters that makes it possible for doctors to recognize even the finest vascular structures. The greater sensitivity of the Stellar Detector also helps doctors when they examine obese patients: The new detector provides diagnostically useful images despite much higher levels of x-ray absorption in larger body masses. "The new detector is the first to deliver excellent images of even very obese patients with a body mass index over 35," says Dr. Stefan Martinoff, director of the Department of Radiology and Nuclear Medicine at the German Heart Centre.
Siemens Healthcare is offering the Stellar Detector in its Somatom Definition Flash and Somatom Definition Edge CT scanners. All existing Somatom Definition Flash and Somatom Definition AS scanners can be upgraded to the new detector. "Upgrading to the Stellar Detector lets us reduce the dose of all examinations by up to 30 percent," says PD Dr. Hatem Alkadhi, chief medical officer at the Department of Diagnostic and Interventional Radiology at the University Hospital in Zurich.
Launched in November 2011 by the Siemens Healthcare Sector, "Agenda 2013" is a two-year global initiative to further strengthen the Healthcare Sector's innovative power and competitiveness. Specific measures will be implemented in four fields of action: Innovation, Competitiveness, Regional Footprint, and People Development.
The products/features (here mentioned) are not commercially available in all countries. Due to regulatory reasons their future availability cannot be guaranteed. Please contact your local Siemens organization for further details.
The statements by Siemens' customers described herein are based on results that were achieved in the customer's unique setting. Since there is no "typical" hospital and many variables exist (e.g., hospital size, case mix, level of IT adoption) there can be no guarantee that other customers will achieve the same results.
The Siemens Healthcare Sector is one of the world's largest suppliers to the healthcare industry and a trendsetter in medical imaging, laboratory diagnostics, medical information technology and hearing aids. Siemens offers its customers products and solutions for the entire range of patient care from a single source – from prevention and early detection to diagnosis, and on to treatment and aftercare. By optimizing clinical workflows for the most common diseases, Siemens also makes healthcare faster, better and more cost-effective. Siemens Healthcare employs some 51,000 employees worldwide and operates around the world. In fiscal year 2011 (to September 30), the Sector posted revenue of 12.5 billion euros and profit of around 1.3 billion euros. For further information please visit: http://www.siemens.com/healthcare
Reference Number: HIM201211037e
Contact
Mr. Ulrich Künzel
Healthcare Sector
Siemens AG
Henkestr. 127
91052 Erlangen
Germany
Tel: +49 (9131) 84-3473
ulrich.kuenzel@siemens.com
Ulrich Künzel | Source: Siemens Healthcare
Further information: www.siemens.com/healthcare
Further Reports about: body mass > CT scan > CT scanner > financial sector > Flash > Healthcare > radiation dose > radiology > Somatom > Stellar Jets
More articles from Medical Engineering:
Varian Software Successfully Connected with Siemens Linear Accelerators
13.06.2013 | Siemens AG
Heart to Heart: Cardiac PET/MR Measures Up To PET/CT
11.06.2013 | Society of Nuclear Medicine
- Biological fermentation process converts CO and CO2 into bioethanol and platform chemicals
- Process uses energy contained in steel plant off-gases
- Ten-year co-operation to develop and market integrated environmental solutions for the steel industry worldwide
Siemens Metals Technologies and LanzaTech have signed a ten-year co-operation agreement to develop and market integrated environmental solutions for the steel industry worldwide. The collaboration will utilize the ground-breaking fermentation technology developed by LanzaTech transforming carbon-rich off-gases generated by the steel industry into low carbon bioethanol and other platform chemicals. ...
Novel application of 3D printing could enable the development of miniaturized medical implants, compact electronics, tiny robots, and more
3D printing can now be used to print lithium-ion microbatteries the size of a grain of sand. The printed microbatteries could supply electricity to tiny devices in fields from medicine to communications, including many that have lingered on lab benches for lack of a battery small enough to fit the ...
... two engines aircraft project “Elektro E6”.
The countdown has been started for opening the gates again for the worldwide leading aviation and space event in Le Bourget, Paris from June 17th - 23rd, 2013.
EADCO & PC-Aero will present at the Paris Air Show in Hall H4 booth F-7 their new future aircraft and innovative project: ...
Siemens scientists have developed new kinds of ceramics in which they can embed transformers.
The new development allows power supply transformers to be reduced to one fifth of their current size so that the normally separate switched-mode power supply units of light-emitting diodes can be integrated into the module's heat sink.
The new technology was developed in cooperation with industrial and research partners who ...
Cheaper clean-energy technologies could be made possible thanks to a new discovery.
Led by Raymond Schaak, a professor of chemistry at Penn State University, research team members have found that an important chemical reaction that generates hydrogen from water is effectively triggered -- or catalyzed -- by a nanoparticle composed of nickel and phosphorus, two inexpensive elements that are abundant on Earth. ...
19.06.2013 | Life Sciences
Rice blast research reveals details on how a fungus invades plants
19.06.2013 | Agricultural and Forestry Science
Gel or whitening? Consumer choice and product organization
19.06.2013 | Studies and Analyses
International Symposium on Morphogenesis
14.06.2013 | Event News
ESMT Annual Forum: CEOs discuss “The Future of Jobs” with international academics and policymakers
13.06.2013 | Event News
Invitation: Mathematics for Industry and Society in the French Embassy Berlin, 04. - 05.07.2013
10.06.2013 | Event News