Forum for Science, Industry and Business

Sponsored by:     3M 
Search our Site:

 

Yellow lights mean drivers have to make right choice -- if they have time

12.09.2012
Length of yellow caution traffic lights could prevent accidents

A couple of years ago, Hesham Rakha misjudged a yellow traffic light and entered an intersection just as the light turned red. A police officer handed him a ticket.


Virginia’s Smart Road, located at the Virginia Tech Transportation Institute, has a signalized intersection with a controllable light.

Credit: Virginia Tech

"There are circumstances, as you approach a yellow light, where the decision is easy. If you are close to the intersection, you keep going. If you are far away, you stop. If you are almost at the intersection, you have to keep going because if you try to stop, you could cause a rear-end crash with the vehicle behind you and would be in the middle of the intersection anyway," said Rakha, professor of civil and environmental engineering at Virginia Tech.

He's not trying to defend his action. Rakha, director of the Center for Sustainable Mobility (www.vtti.vt.edu/csm.php) at the Virginia Tech Transportation Institute (www.vtti.vt.edu), is describing his research. Since 2005, his research group has been studying drivers' behaviors as they approach yellow lights. Their goal is to determine signal times for intersections that are safer and still efficient.

If a driver decides to stop when instead of proceeding, rear-end crashes could occur. If a driver proceeds instead of stopping, collisions with side street traffic could occur. Although observation-based research shows that only 1.4 percent of drivers cross the stop line after the light turns red, more than 20 percent of traffic fatalities in the United States occur at intersections.

"If the yellow time is not set correctly, a dilemma zone is imminent," Rakha said.

"The dilemma zone occurs when the driver has no feasible choice," he said. "In other words the driver can neither stop nor proceed through the intersection before the light turns red. This can also occur if the approaching vehicle is traveling faster than the posted speed limit and/or if the driver's perception and reaction time is longer than the design one-second value."

In most cases, the yellow time is set for 4.2 seconds on a 45 mph road. The time is longer for higher-speed roads. "These timings are based on two assumptions," Rakha explains. "Namely, the driver requires one second to perceive and react to the change in signal indication and that the driver requires 3.2 seconds to stop from 45 mph at a comfortable deceleration level, assumed to be 3 meters per second squared (3 m/s2 ) or 10 feet per second squared."

For his studies, Rakha's used Virginia's Smart Road, located at the Virginia Tech Transportation Institute. The Smart Road intersection has a signal that can be controlled for length of the red, yellow and green lights. "We can study driver behavior by changing the signal when the driver is a certain distance from the intersection."

Center for Sustainable Mobility researchers have determined that half of drivers make the stop-go decision three seconds before the stop line. Of those that go, few clear the intersection before the light changes to red. In Virginia, if you are in the intersection when the light turns red, you are not running a red light. However, there is still risk.

The specific findings from the Smart Road study are that 43 percent of drivers who crossed the stop line during the yellow time were not able to clear the intersection before the light turned red. At 45 mph, it takes 1.5 seconds to clear a 30-meter (98.4 feet) intersection. "If the all-red interval is the minimum conventional one second, then there is a potential risk that the legal yellow-light runners would not be able to completely clear the intersection at the instant the side-street traffic gains the right-of-way," the researchers reported at the Transportation Research Board Annual Meeting in 2010.

People over 60 years of age have a longer perception-reaction time, so they have to brake harder to stop. But they are more likely to try to stop, compared to younger drivers. However, if they keep going, they are unlikely to clear the intersection, the researchers report.

"Even if yellow timing is designed properly to avoid a dilemma zone, someone driving above the speed limit could encounter a dilemma because it takes longer to stop from a higher speed. They could speed up, but our studies show that drivers who keep going usually maintain their speed," Rakha said.

The research determined that the perception-reaction time is slightly longer than one second, but that driver deceleration levels are significantly higher than the deceleration level assumed for traffic signal design.

If the road conditions are poor, drivers react 15 percent slower because they are processing more information. Deceleration level decreases by 8 percent. "In such conditions, you need a longer yellow," Rakha said.

He and his team has developed a novel procedure to compute the yellow and change interval duration that accounts for the risk of drivers being caught in the dilemma zone. Using this procedure they have created tables for light vehicles at various speeds for dry roads and wet roads, so that traffic planners can set traffic signals that can be adjusted to roadway surface and weather conditions. They also created tables for the driving characteristics for different age groups.

One strategy to make intersections safer might be more use of caution lights that tell drivers a green light is about to change, so the driver has a longer time to react. Such systems now are used on high speed roads, where the stopping distance is longer, and when the lighted intersection is not visible until the last seconds.

A future strategy that researchers are investigating is in-car display systems that can be customized to each driver's reaction time. "So one person receives a four-second warning of a light change, and another person receives a five-second warning. Or, instead of a warning, the system might just tell you to stop," said Rakha.

Research to implement vehicle-to-vehicle and infrastructure-to-vehicle communication is ongoing, including at the Virginia Tech Transportation Institute Tier 1 University Transportation Center. Rakha's research group is studying vehicle-to-vehicle communication at intersections.

The research has been presented at the 2010 and 2011 Transportation Research Board annual meetings. Articles published in 2012 are:

"Novel Stochastic Procedure for Designing Yellow Intervals at Signalized Intersections," by Ahmed Amer, transportation engineer with Vanasse Hangen Brustlin Inc.; Rakha; and Ihab El- Shawarby, assistant professor at Ain-Shams University in Cairo and senior research associate with the Center for Sustainable Mobility at the Virginia Tech Transportation Institute. It appeared in the June 1, 2012, Journal of Transportation Engineering.

"Designing Yellow Intervals for Rainy and Wet Roadway Conditions," by Huan Li of Blacksburg, who has received his master of science degree in civil engineering; Rakha; and El-Shawarby. The article appeared in the spring 2012 issue of the International Journal of Transportation Science and Technology.

Sherri Box | EurekAlert!
Further information:
http://www.vt.edu

More articles from Transportation and Logistics:

nachricht Tool helps cities to plan electric bus routes, and calculate the benefits
09.01.2017 | International Institute for Applied Systems Analysis (IIASA)

nachricht Realistic training for extreme flight conditions
28.12.2016 | Technical University of Munich (TUM)

All articles from Transportation and Logistics >>>

The most recent press releases about innovation >>>

Die letzten 5 Focus-News des innovations-reports im Überblick:

Im Focus: A Challenging European Research Project to Develop New Tiny Microscopes

The Institute of Semiconductor Technology and the Institute of Physical and Theoretical Chemistry, both members of the Laboratory for Emerging Nanometrology (LENA), at Technische Universität Braunschweig are partners in a new European research project entitled ChipScope, which aims to develop a completely new and extremely small optical microscope capable of observing the interior of living cells in real time. A consortium of 7 partners from 5 countries will tackle this issue with very ambitious objectives during a four-year research program.

To demonstrate the usefulness of this new scientific tool, at the end of the project the developed chip-sized microscope will be used to observe in real-time...

Im Focus: Giant Magnetic Fields in the Universe

Astronomers from Bonn and Tautenburg in Thuringia (Germany) used the 100-m radio telescope at Effelsberg to observe several galaxy clusters. At the edges of these large accumulations of dark matter, stellar systems (galaxies), hot gas, and charged particles, they found magnetic fields that are exceptionally ordered over distances of many million light years. This makes them the most extended magnetic fields in the universe known so far.

The results will be published on March 22 in the journal „Astronomy & Astrophysics“.

Galaxy clusters are the largest gravitationally bound structures in the universe. With a typical extent of about 10 million light years, i.e. 100 times the...

Im Focus: Tracing down linear ubiquitination

Researchers at the Goethe University Frankfurt, together with partners from the University of Tübingen in Germany and Queen Mary University as well as Francis Crick Institute from London (UK) have developed a novel technology to decipher the secret ubiquitin code.

Ubiquitin is a small protein that can be linked to other cellular proteins, thereby controlling and modulating their functions. The attachment occurs in many...

Im Focus: Perovskite edges can be tuned for optoelectronic performance

Layered 2D material improves efficiency for solar cells and LEDs

In the eternal search for next generation high-efficiency solar cells and LEDs, scientists at Los Alamos National Laboratory and their partners are creating...

Im Focus: Polymer-coated silicon nanosheets as alternative to graphene: A perfect team for nanoelectronics

Silicon nanosheets are thin, two-dimensional layers with exceptional optoelectronic properties very similar to those of graphene. Albeit, the nanosheets are less stable. Now researchers at the Technical University of Munich (TUM) have, for the first time ever, produced a composite material combining silicon nanosheets and a polymer that is both UV-resistant and easy to process. This brings the scientists a significant step closer to industrial applications like flexible displays and photosensors.

Silicon nanosheets are thin, two-dimensional layers with exceptional optoelectronic properties very similar to those of graphene. Albeit, the nanosheets are...

All Focus news of the innovation-report >>>

Anzeige

Anzeige

Event News

International Land Use Symposium ILUS 2017: Call for Abstracts and Registration open

20.03.2017 | Event News

CONNECT 2017: International congress on connective tissue

14.03.2017 | Event News

ICTM Conference: Turbine Construction between Big Data and Additive Manufacturing

07.03.2017 | Event News

 
Latest News

Transport of molecular motors into cilia

28.03.2017 | Life Sciences

A novel hybrid UAV that may change the way people operate drones

28.03.2017 | Information Technology

NASA spacecraft investigate clues in radiation belts

28.03.2017 | Physics and Astronomy

VideoLinks
B2B-VideoLinks
More VideoLinks >>>