Forum for Science, Industry and Business

Sponsored by:     3M 
Search our Site:

 

Engineers image nanostructure of a solid acid catalyst and boost its catalytic activity

11.11.2009
Researchers from Lehigh and Rice universities combine electron microscopy and spectroscopy techniques to shed new light on a tungstated zirconia catalyst

The catalytic processes that facilitate the production of many chemicals and fuels could become much more environmentally friendly thanks to a breakthrough achieved by researchers from Lehigh and Rice Universities.

In an article published Nov. 8 by the journal Nature Chemistry, the researchers report a novel electron microscopy imaging study of a tungstated zirconia solid acid catalyst. Based on new information obtained from these images, the researchers were able to design a preparation procedure that increased the activity of the catalyst by more than 100 times.

A catalyst is a substance that accelerates the rate of a chemical reaction without itself being consumed by that reaction. Liquid acid catalysts are widely used in the production of many chemicals but pose environmental concerns due to evaporation, spilling and corrosion. Chemical companies are seeking to replace liquid catalysts with solid acid catalysts, which can be more cleanly used and disposed of because they do not evaporate, spill or lead to corrosion.

The Lehigh-Rice team used aberration-corrected scanning transmission electron microscopy (STEM) and advanced optical microscopy and spectroscopy techniques, including Raman, infrared and ultraviolet-violet visible spectroscopies, to shed light on the nanostructure and nanoscale behavior of a tungstated zirconia solid acid catalyst. Among other applications, tungstated zirconia is used to improve the octane content of gasoline through a process called isomerization, in which a straight chain alkane molecule is converted into a branched chain molecule.

The team was able to directly image a variety of tungsten-oxide species, including monomers, polymer-like chains and sub-nanometer clusters, which were supported on a nanocrystalline zirconia substrate. Catalytic performance studies revealed that the most active catalytic species are tungsten oxide clusters that measure only 0.8 to 1 nm in diameter and are mixed with a few zirconium atoms emanating from the support. A nanometer is one-billionth of a meter, or about the diameter of 10 hydrogen atoms.

The team then deliberately deposited the catalytically active sub-nanometer mixed tungsten-zirconium oxide clusters onto a tungstated zirconia catalyst that previously had possessed low catalytic activity. When the catalytic activity of the poor catalyst was found to have improved by two orders of magnitude, the team's hypothesis about the identity and structure of the active species within the tungstated zirconia material was confirmed. The researchers have filed a patent application for their new catalyst preparation method.

The Nature Chemistry article, titled "Identification of active Zr-WOx clusters on a ZrO2 support for solid acid catalysts," has six authors. Wu Zhou, the lead author, is a Ph.D. candidate in materials science and engineering at Lehigh. The other authors are Elizabeth Ross-Medgaarden, who earned a Ph.D. in chemical engineering from Lehigh in 2007; William V. Knowles, who earned a Ph.D. in chemical and biomolecular engineering from Rice in 2006; Michael S. Wong, associate professor of chemical and biomolecular engineering and of chemistry at Rice; Israel E. Wachs, professor of chemical engineering at Lehigh; and Christopher J. Kiely, professor of materials science and engineering at Lehigh, who is also the corresponding author of the paper.

The research was funded by the National Science Foundation through its Nanoscale Interdisciplinary Research Team (NSF-NIRT) program. Wachs, who directs Lehigh's Operando Molecular Spectroscopy and Catalysis Laboratory, is principal investigator on the grant. Kiely, director of Lehigh's Nanocharacterization Laboratory, is co-principal investigator, as is Wong, who directs the Catalysis and Nanomaterials Laboratory at Rice.

The Lehigh-Rice team also collaborates closely with Matthew Neurock, a professor of chemical engineering and an expert in computational and theoretical catalysis at the University of Virginia. Neurock is a co-PI on the NSF-NIRT project.

A new view of an old problem

The Lehigh-Rice team attributes much of its success to the use, for the first time on tungstated zirconia catalysts, of aberration-corrected scanning transmission electron microscopy (STEM) and its integration with three optical spectroscopic techniques—Raman, infrared and ultraviolet-visible. Only by combining the microscopy and spectroscopy studies, says Wachs, was it possible to obtain the insights at the molecular level that are required to pinpoint the origin of the acidity of the tungstated zirconia.

Lehigh four years ago became the first university in the world to acquire two aberration-corrected STEM instruments. The VG HB 603 STEM can map the chemical composition of nanoparticles, while the JEOL 2200 FS STEM has unparalleled imaging capabilities. The researchers employed a microscopy technique called high-angle annular dark-field imaging (HAADF), which uses a focused beam of electrons only 1 angstrom (0.1 nm) wide, to obtain clear images of the supported tungsten oxide species.

"HAADF imaging of tungstated zirconia catalysts in an aberration-corrected STEM allows, for the first time, direct imaging of the various [catalytic] species present," the researchers wrote in Nature Chemistry.

Wachs, who is internationally renowned for his work in catalysis and his expertise in Raman and other spectroscopy techniques, especially under reaction conditions, said the aberration-corrected STEMs has opened an unprecedented window on the structure and size of the catalytic species.

"This new generation of aberration-corrected STEMs enables us finally to see the dimensions of the species we're studying," says Wachs. "We can see monomers, dimers and trimers, as well as larger clusters of tungsten oxide."

The researchers used information gleaned from the aberration-corrected STEM studies in concert with data obtained from Raman, IR and UV-visible spectroscopy, and from controlled catalyst testing studies, to molecularly engineer a better catalyst, says Wachs. The spectroscopy experiments were performed in situ as catalysis was occurring over the tungstated zirconia.

Wachs' Operando Molecular Spectroscopy and Catalysis Laboratory is home to the most advanced optical spectroscopic instrumentation in catalysis in America. The high resolution-Raman spectrometer (Horiba Scientific LabRaman-HR) is integrated with IR and UV-visible spectroscopy in one system to enable the contemporaneous collection of multiple spectroscopic information from the same catalyst spot. The optical techniques also function under reaction conditions (gas-solid and aqueous-solid) and the effluent reaction products from the catalytic reactor cell are simultaneously monitored with mass spectrometry. All information is collected in real time (nanosecond to second range).

"The combination of these imaging and spectroscopy techniques enabled us to make a an active catalytic site, deposit it on a catalyst with low activity, and show a 100-fold improvement in catalytic activity," says Wachs. "In short, we've been able to design, on demand, the active catalytic sites by molecularly engineering the catalyst.

"These imaging and specstroscopy techniques are very complementary. They are like multiple pairs of eyes that help us see what is going on at the atomic and molecular scale during the catalytic reaction."

Clearing up a mystery

Lehigh's STEM instruments are equipped with spherical aberration correctors that improve imaging and chemical mapping resolution by overcoming distortions in the lenses that focus the electron beams onto the specimen. This improved resolution enables researchers to view individual atoms, especially of heavy elements like tungsten.

"Using conventional high resolution electron microscopy, it is next to impossible to see individual tungsten atoms on the zirconia substrate," says Zhou. "If you can correct the spherical aberration in the microscopy, this allows you in HAADF mode to pick up the heavy tungsten atoms, which show up as bright specks against the lighter zirconia substrate."

The ability to visualize individual supported atoms, Zhou adds, has helped solve a mystery that has puzzled scientists since the tungstated zirconia catalyst was developed two decades ago by researchers in Japan, namely, which specific structural feature of the catalyst is responsible for its catalytic activity?

Being able to see individual tungsten atoms allowed the researchers to identify the active catalytic sites in these solid acid catalysts. The team took a set of samples, some with low catalytic activity, some with high activity, and compared their nanostructures. In both sets of samples, they found isolated monomers and linked chains of polymeric tungstate species, which turn out to have little catalytic activity.

"Only in the samples with high catalytic activity," says Zhou, "did we find 3-D mixed zirconium-tungsten oxide clusters, less than 1 nm in size, which are the active catalytic sites in these solid acid catalysts."

"By identifying the nano feature that is responsible for the desired catalytic performance," says Wong, who is an expert in catalyst synthesis and materials chemistry, "we can then focus research efforts on rationally designing new ways to prepare catalytic materials with only that particular feature."

Kiely published a related catalysis paper in Science last fall in which he reported that individual atoms of gold on a metal oxide were imaged using the aberration-corrected HAADF method.

"It has already been established that the dispersion of a metal on a metal-oxide support could be seen with aberration-corrected electron microscopy," he says. "This new Nature Chemistry study is the first report of the use of aberration-corrected microscopy to image the atomic structure of a metal oxide overlayer deposited onto a metal-oxide support."

The Lehigh-Rice NIRT team published an article earlier this year in the Journal of the American Chemical Society that describes how the integration of microscopy and spectroscopy allowed for the tuning of the electronic and molecular structures of nanostructured catalytic active sites for acid and redox reactions. This integration is now being applied to the molecular engineering of catalysts used in the production of clean liquid fuels and in the manufacture of agents that control power plant emissions responsible for acid rain.

Kurt Pfitzer | EurekAlert!
Further information:
http://www.lehigh.edu

More articles from Life Sciences:

nachricht Nanoparticle Exposure Can Awaken Dormant Viruses in the Lungs
16.01.2017 | Helmholtz Zentrum München - Deutsches Forschungszentrum für Gesundheit und Umwelt

nachricht Cholera bacteria infect more effectively with a simple twist of shape
13.01.2017 | Princeton University

All articles from Life Sciences >>>

The most recent press releases about innovation >>>

Die letzten 5 Focus-News des innovations-reports im Überblick:

Im Focus: Designing Architecture with Solar Building Envelopes

Among the general public, solar thermal energy is currently associated with dark blue, rectangular collectors on building roofs. Technologies are needed for aesthetically high quality architecture which offer the architect more room for manoeuvre when it comes to low- and plus-energy buildings. With the “ArKol” project, researchers at Fraunhofer ISE together with partners are currently developing two façade collectors for solar thermal energy generation, which permit a high degree of design flexibility: a strip collector for opaque façade sections and a solar thermal blind for transparent sections. The current state of the two developments will be presented at the BAU 2017 trade fair.

As part of the “ArKol – development of architecturally highly integrated façade collectors with heat pipes” project, Fraunhofer ISE together with its partners...

Im Focus: How to inflate a hardened concrete shell with a weight of 80 t

At TU Wien, an alternative for resource intensive formwork for the construction of concrete domes was developed. It is now used in a test dome for the Austrian Federal Railways Infrastructure (ÖBB Infrastruktur).

Concrete shells are efficient structures, but not very resource efficient. The formwork for the construction of concrete domes alone requires a high amount of...

Im Focus: Bacterial Pac Man molecule snaps at sugar

Many pathogens use certain sugar compounds from their host to help conceal themselves against the immune system. Scientists at the University of Bonn have now, in cooperation with researchers at the University of York in the United Kingdom, analyzed the dynamics of a bacterial molecule that is involved in this process. They demonstrate that the protein grabs onto the sugar molecule with a Pac Man-like chewing motion and holds it until it can be used. Their results could help design therapeutics that could make the protein poorer at grabbing and holding and hence compromise the pathogen in the host. The study has now been published in “Biophysical Journal”.

The cells of the mouth, nose and intestinal mucosa produce large quantities of a chemical called sialic acid. Many bacteria possess a special transport system...

Im Focus: Newly proposed reference datasets improve weather satellite data quality

UMD, NOAA collaboration demonstrates suitability of in-orbit datasets for weather satellite calibration

"Traffic and weather, together on the hour!" blasts your local radio station, while your smartphone knows the weather halfway across the world. A network of...

Im Focus: Repairing defects in fiber-reinforced plastics more efficiently

Fiber-reinforced plastics (FRP) are frequently used in the aeronautic and automobile industry. However, the repair of workpieces made of these composite materials is often less profitable than exchanging the part. In order to increase the lifetime of FRP parts and to make them more eco-efficient, the Laser Zentrum Hannover e.V. (LZH) and the Apodius GmbH want to combine a new measuring device for fiber layer orientation with an innovative laser-based repair process.

Defects in FRP pieces may be production or operation-related. Whether or not repair is cost-effective depends on the geometry of the defective area, the tools...

All Focus news of the innovation-report >>>

Anzeige

Anzeige

Event News

12V, 48V, high-voltage – trends in E/E automotive architecture

10.01.2017 | Event News

2nd Conference on Non-Textual Information on 10 and 11 May 2017 in Hannover

09.01.2017 | Event News

Nothing will happen without batteries making it happen!

05.01.2017 | Event News

 
Latest News

Multiregional brain on a chip

16.01.2017 | Power and Electrical Engineering

New technology enables 5-D imaging in live animals, humans

16.01.2017 | Information Technology

Researchers develop environmentally friendly soy air filter

16.01.2017 | Power and Electrical Engineering

VideoLinks
B2B-VideoLinks
More VideoLinks >>>