The development of the hard disk is now reaching its technical limits because the entire disk is served by just a single head. Consequently, the capacity of the disk and the reading and writing speed cannot expand much more in the future.
Therefore research into a memory based on probes is being carried out at the University of Twente’s MESA+ research institute. Being able to control the position of each separate probe is essential for realising a system with extremely high densities.
Le Fèbre's measurements show that a field-emission current signal can be used to adjust the position of the probes without these making direct contact with the storage medium. If a constant current is maintained and the applied voltage is varied, the distance between the probe apex and the storage medium can be adjusted from several nanometres to about 100 nanometres.
The resolution is sufficient for a probe-based storage system. However for practical applications, the current stability and the lifetime of the probes will need to be improved further so that the accuracy and reproducibility of positioning can be increased.
Alexander le Febre | EurekAlert!
Safe glide at total engine failure with ELA-inside
27.02.2017 | FernUniversität in Hagen
Deep Learning predicts hematopoietic stem cell development
21.02.2017 | Helmholtz Zentrum München - Deutsches Forschungszentrum für Gesundheit und Umwelt
On January 15, 2009, Chesley B. Sullenberger was celebrated world-wide: after the two engines had failed due to bird strike, he and his flight crew succeeded after a glide flight with an Airbus A320 in ditching on the Hudson River. All 155 people on board were saved.
On January 15, 2009, Chesley B. Sullenberger was celebrated world-wide: after the two engines had failed due to bird strike, he and his flight crew succeeded...
In the field of nanoscience, an international team of physicists with participants from Konstanz has achieved a breakthrough in understanding heat transport
Cells need to repair damaged DNA in our genes to prevent the development of cancer and other diseases. Our cells therefore activate and send “repair-proteins”...
The Fraunhofer IWS Dresden and Technische Universität Dresden inaugurated their jointly operated Center for Additive Manufacturing Dresden (AMCD) with a festive ceremony on February 7, 2017. Scientists from various disciplines perform research on materials, additive manufacturing processes and innovative technologies, which build up components in a layer by layer process. This technology opens up new horizons for component design and combinations of functions. For example during fabrication, electrical conductors and sensors are already able to be additively manufactured into components. They provide information about stress conditions of a product during operation.
The 3D-printing technology, or additive manufacturing as it is often called, has long made the step out of scientific research laboratories into industrial...
Nature does amazing things with limited design materials. Grass, for example, can support its own weight, resist strong wind loads, and recover after being...
13.02.2017 | Event News
10.02.2017 | Event News
09.02.2017 | Event News
28.02.2017 | Physics and Astronomy
28.02.2017 | Materials Sciences
28.02.2017 | Health and Medicine