Forum for Science, Industry and Business
  • Sponsored by:
  • Siemens
  • Siemens
  • Siemens
Search our Site:

Topic (optional):

 

Home Reports Power and Electrical Engineering Content

NIST develops test method for key micromechanical property

next article
11.01.2008

Engineers and researchers designing and building new microelectromechanical systems (MEMS) can benefit from a new test method developed at the National Institute of Standards and Technology (NIST) to measure a key mechanical property of such systems: elasticity. The new method determines the “Young’s modulus” of thin films not only for MEMS devices but also for semiconductor devices in integrated circuits.

 

Since 1727, scientists and engineers have used Young’s modulus as a measure of the stiffness of a given material. Defined as the ratio of stress (such as the force per unit area pushing on both ends of a beam) to strain (the amount the beam is deflected), Young’s modulus allows the behavior of a material under load to be calculated.


Young’s modulus predicts the length a wire will stretch under tension or the amount of compression that will buckle a thin film. A standard method to determine this important parameter—a necessity to ensure that measurements of Young’s modulus made at different locations are comparable—has eluded those who design, manufacture and test MEMS devices, particularly in the semiconductor industry.

A team at NIST recently led the effort to develop SEMI Standard MS4-1107, “Test Method for Young’s Modulus Measurements of Thin, Reflecting Films Based on the Frequency of Beams in Resonance.” The new standard applies to thin films (such as those found in MEMS materials) that can be imaged using an optical vibrometer or comparable instrument for non-contact measurements of surface motion. In particular, measurements are obtained from resonating beams—comprised of the thin film layer—that oscillate out-of-plane.

The frequency at which the maximum amplitude (or velocity) of vibration is achieved is a resonance frequency, which is used to calculate the Young’s modulus of the thin film layer. The group also developed a special Web-based “MEMS calculator” (http://www.eeel.nist.gov/812/test-structures/MEMSCalculator.htm) that can be used to determine specific thin film properties from data taken with an optical interferometer.

Knowledge of the Young’s modulus values and the residual strain (using ASTM International Standard E 2245) for thin film layers can lead to calculations of residual stress, which in turn, enable semiconductor manufacturers to develop circuit design strategies, fabrication systems and post-processing methods that could increase fabrication yield by reducing the frequency of failures from electromigration, stress migration and delamination.

Michael E. Newman | Source: EurekAlert!
Further information: www.nist.gov
www.eeel.nist.gov/812/test-structures/MEMSCalculator.htm

next article

More articles from Power and Electrical Engineering:

nachricht The European Union wants to reduce electrical appliance stand-by energy consumption
23.07.2008 | Bundesanstalt für Materialforschung und -prüfung (BAM)

nachricht “Nanosculpture” Could Enable New Types of Heat Pumps and Energy Converters
21.07.2008 | Rensselaer Polytechnic Institute (RPI)

B2B Search

Product / Service
Company / Organisation

Latest News

Object intermediate between normal supernovae and gamma-ray bursts found

25.07.2008 | Physics and Astronomy

Leeds project aims to boost parents’ confidence in MMR choices as measles rates rise

25.07.2008 | Health and Medicine

COROT’s new find orbits Sun-like star

25.07.2008 | Physics and Astronomy