The metal-oxide, indium tin oxide (ITO), is a transparent conductor used as the anode for flat screen displays, and has been the standard for decades. Due to indium's limited supply, increasing cost and the increasing demand for its use in screen and lighting technologies, the U.S. Department of Energy has designated indium as "near-critical" in its assessment of materials vital to clean energy technology. Scientists have been working to find an energy efficient, cost effective substitute.
“There are not many materials that are both transparent and electrically conductive,” said Joseph Shinar, an Ames Laboratory Senior Scientist. “One hundred percent of commercial display devices in the world use ITO as the transparent conducting electrode. There’s been a big push for many years to find alternatives.”
“Everybody is trying to find a replacement for ITO, many working with zinc oxide, another metal oxide. But here we are working towards something different, developing ways to use a conducting polymer,” said Min Cai, a post-doctoral research scientist in the Ames Laboratory and the Dept. of Physics and Astronomy at Iowa State University.
The polymer’s name is a mouthful of a word: poly (3,4-ethylene dioxythiophene):poly(styrene sulfonate), known as PEDOT:PSS for short, and has been around for about 15 years. Until recently, the material wasn’t sufficiently conductive or transparent enough to be a viable ITO substitute, Shinar said. But by using a multi-layering technique and special treatments, Cai and his fellow scientists were able to fabricate PEDOT:PSS OLEDs with vastly improved properties.
“Compared to an ITO anode device, the PEDOT:PSS device is at least 44 percent more efficient,” said Cai. According to Joe
Shinar, that gain in efficiency over ITO-based technology is the highest yet recorded.
The researchers used computer simulations to show that the enhanced performance is largely an effect of the difference in the optical properties between the polymer- and ITO-based devices.
Another key property of PEDOT:PSS is flexibility; using ITO in OLEDs defeats one of OLED’s big pluses compared to conventional LED technology.
“OLEDs can be made on a flexible substrate, which is one of their principal advantages over LEDs. But ITO is ceramic in nature; it is brittle rather than flexible,” said Ruth Shinar, a Senior Scientist at Iowa State University’s Microelectronics Research Center.
The findings, co-authored by Joseph Shinar and Ruth Shinar along with Min Cai, Zhuo Ye, Teng Xiao, Rui Liu, Ying Chen, Robert W. Mayer, Rana Biswas, and Kai-Ming Ho, were recently published in Advanced Materials, one of the most prominent journals in materials science and engineering.
The research builds on continuing work to find more affordable and efficient manufacturing materials and processes for OLED manufacturing. An earlier paper published in Advanced Materials by Joseph Shinar and Ruth Shinar along with Min Cai , Teng Xiao , Emily Hellerich , and Ying Chen demonstrated the use of solution processing for small molecule-based OLEDs, which are typically constructed using a more expensive thermal evaporation deposition process.
The scientists’ ongoing investigations into better materials and processes pave the way to more cost-efficient manufacturing and making OLED technology more widely available to consumers.
Joseph Shinar said that OLED televisions were already available to a limited high-end consumer, and that prices would come down as major manufacturers perfected their production processes. Both Samsung and LG exhibited a 55-inch OLED TV as a highlight feature of the 2012 Consumer Electronics Show in Las Vegas in January.
“We are already getting there with OLED televisions. Consumers will see them getting more affordable and more widely available in the very near future,” said Joseph Shinar.
Shinar said the technology was also beginning to be used in lighting, in applications where diffuse light is preferred instead of point source lighting, and in architectural and art design.
The research is supported by the U.S. Department of Energy’s Office of Science. DOE’s Office of Science is the single largest supporter of basic research in the physical sciences in the United States, and is working to address some of the most pressing challenges of our time. For more information, please visit the Office of Science website at science.energy.gov/.
The Ames Laboratory is a U.S. Department of Energy Office of Science national laboratory operated by Iowa State University. The Ames Laboratory creates innovative materials, technologies and energy solutions. We use our expertise, unique capabilities and interdisciplinary collaborations to solve global problems.
Laura Millsaps | Source: EurekAlert!
Further information: www.ameslab.gov
More articles from Power and Electrical Engineering:
Not Just Blowing in the Wind: Compressing Air for Renewable Energy Storage
22.05.2013 | Pacific Northwest National Laboratory
Iowa State Engineers Design, Test Taller, High-Strength Concrete Towers for Wind Turbines
16.05.2013 | Iowa State University
A fried breakfast food popular in Spain provided the inspiration for the development of doughnut-shaped droplets that may provide scientists with a new approach for studying fundamental issues in physics, mathematics and materials.
The doughnut-shaped droplets, a shape known as toroidal, are formed from two dissimilar liquids using a simple rotating stage and an injection needle. About a millimeter in overall size, the droplets are produced individually, their shapes maintained by a surrounding springy material made of polymers.
Droplets in this toroidal shape made ...
Frauhofer FEP will present a novel roll-to-roll manufacturing process for high-barriers and functional films for flexible displays at the SID DisplayWeek 2013 in Vancouver – the International showcase for the Display Industry.
Displays that are flexible and paper thin at the same time?! What might still seem like science fiction will be a major topic at the SID Display Week 2013 that currently takes place in Vancouver in Canada.
High manufacturing cost and a short lifetime are still a major obstacle on ...
University of Würzburg physicists have succeeded in creating a new type of laser.
Its operation principle is completely different from conventional devices, which opens up the possibility of a significantly reduced energy input requirement. The researchers report their work in the current issue of Nature.
It also emits light the waves of which are in phase with one another: the polariton laser, developed ...
Innsbruck physicists led by Rainer Blatt and Peter Zoller experimentally gained a deep insight into the nature of quantum mechanical phase transitions.
They are the first scientists that simulated the competition between two rival dynamical processes at a novel type of transition between two quantum mechanical orders. They have published the results of their work in the journal Nature Physics.
“When water boils, its molecules are released as vapor. We call this ...
Researchers have shown that, by using global positioning systems (GPS) to measure ground deformation caused by a large underwater earthquake, they can provide accurate warning of the resulting tsunami in just a few minutes after the earthquake onset.
For the devastating Japan 2011 event, the team reveals that the analysis of the GPS data and issue of a detailed tsunami alert would have taken no more than three minutes. The results are published on 17 May in Natural Hazards and Earth System Sciences, an open access journal of ...
22.05.2013 | Life Sciences
22.05.2013 | Ecology, The Environment and Conservation
22.05.2013 | Earth Sciences
17.05.2013 | Event News
15.05.2013 | Event News
08.05.2013 | Event News