Forum for Science, Industry and Business

Sponsored by:     3M 
Search our Site:

 

ETH Zurich competence center ESC introduces energy strategy. Long-term objective 1-ton CO2 society

26.02.2008
In the past year, various reports from the United Nations’ Intergovernmental Panel on Climate Change (IPCC) have warned the world in no uncertain terms that in order to achieve a stable climate on our planet by the end of this century, any increase in CO2 emissions in the coming decades must be curbed before the emissions can be appreciably reduced. According to the IPCC, the maxi-mum amount of CO2 emissions that can be tolerated globally by the end of the 21st century amounts to roughly 2000 gigatons. This will mean a considerable reduction in the emission of CO2 per capita.

The per capita emission of carbon dioxide in Switzerland is currently 9 tons per year, approximately twice the global average. «Our objective for the climate and energy policy for the century has to be to induce each member of the human race to produce not more than 1 ton of carbon dioxide per year», Professor Ralph Eichler, President ETH Zurich, explained to the media today.

Systematic implementation of 3E strategy

This proposed emission target for carbon dioxide may seem ambitious by to-day’s standards, but it can be achieved by the end of the century both in Swit-zerland and throughout the world. This is reflected in the calculations made by ETH Zurich’s own Energy Science Center (ESC). In order to reach the target, an energy strategy will have to be consistently implemented. As stated by Profes-sor Konstantinos Boulouchos, the proposed strategy is based on three pillars: 1) the exhaustion of efficiency potential, 2) the extended use of renewable energy sources and 3) the increased share of electricity in the energy mix.

Exhausting the efficiency potential will mean increasing efficiency in every link of the energy conversion chain, from extraction at the energy source, through stor-age and distribution up to energy usage. This alone would harbour great sav-ings potential, especially when combined with market-based instruments to in-fluence the demand side.

The second E of the strategy focuses on the use of renewable energy sources, such as photovoltaics, water, and wind. Important to note is that economic as well as ecological aspects must be taken into consideration when using renew-able energy sources.

Electricity as the backbone of the energy system

The newcomer to the 3-E strategy constitutes the third E: electrification. Accord-ing to ETH Zurich researchers, in future C02 poor electricity will establish itself as the backbone of a sustainable energy system. It is increasingly being used in heating and cooling buildings (with heat pumps, for example), and is expected to extend to individual mobility (moving, in the long run, from hybrid vehicles to fully electric cars).

A reorientation of the energy system, however, will not happen overnight. It is likely to take several decades. All the more reason that it is crucial that steps be taken today: infrastructure in industrialized countries (transmission network, power plants) needs to be renewed and in threshold countries, erected.

Innovative research at ETH Zurich

ETH Zurich conducts intensive research with a mind to finding new solutions and methods to face the CO2 problem. Professor Marco Mazzotti from the Insti-tute for Process Engineering is researching the possibilities of eliminating CO2 in fossil-fueled power stations and combining it with stable and solid substances. This so-called mineralization thus facilitates the permanent and secure storage of greenhouse gases. Power electronics are becoming increasingly smaller and more efficient: the research group headed by Professor Johann Kolar from the Power Electronic Systems Laboratory is devoted to developing such compo-nents that are deployed, for example, in hybrid vehicles. Efficient control of the drive system of such cars makes a significant contribution towards environmen-tally-friendly private transport.

Promising ETH Zurich research is also being carried out in the field of building systems engineering. The technology at our fingertips today would already en-able us to replace CO2-emitting heating and boiler systems with a combination of innovative wall insulation and heat pumps – with free renewable energy from the ground. This ingenious concept is also just the ticket for existing buildings. «We just need to get cracking», explains Professor HansJürg Leibundgut from the Institute for Building Systems. Within five to six years it should be possible to produce the necessary components on an industrial level so that for the price of a mid-range car, a four-room apartment can be refurbished, with the effect that practically all of the CO2 previously generated by heating and warm water can be prevented.

Prof. Konstantinos Boulouchos | alfa
Further information:
http://www.esc.ethz.ch/

More articles from Power and Electrical Engineering:

nachricht Did you know that the wrapping of Easter eggs benefits from specialty light sources?
13.04.2017 | Heraeus Noblelight GmbH

nachricht To e-, or not to e-, the question for the exotic 'Si-III' phase of silicon
05.04.2017 | Carnegie Institution for Science

All articles from Power and Electrical Engineering >>>

The most recent press releases about innovation >>>

Die letzten 5 Focus-News des innovations-reports im Überblick:

Im Focus: Making lightweight construction suitable for series production

More and more automobile companies are focusing on body parts made of carbon fiber reinforced plastics (CFRP). However, manufacturing and repair costs must be further reduced in order to make CFRP more economical in use. Together with the Volkswagen AG and five other partners in the project HolQueSt 3D, the Laser Zentrum Hannover e.V. (LZH) has developed laser processes for the automatic trimming, drilling and repair of three-dimensional components.

Automated manufacturing processes are the basis for ultimately establishing the series production of CFRP components. In the project HolQueSt 3D, the LZH has...

Im Focus: Wonder material? Novel nanotube structure strengthens thin films for flexible electronics

Reflecting the structure of composites found in nature and the ancient world, researchers at the University of Illinois at Urbana-Champaign have synthesized thin carbon nanotube (CNT) textiles that exhibit both high electrical conductivity and a level of toughness that is about fifty times higher than copper films, currently used in electronics.

"The structural robustness of thin metal films has significant importance for the reliable operation of smart skin and flexible electronics including...

Im Focus: Deep inside Galaxy M87

The nearby, giant radio galaxy M87 hosts a supermassive black hole (BH) and is well-known for its bright jet dominating the spectrum over ten orders of magnitude in frequency. Due to its proximity, jet prominence, and the large black hole mass, M87 is the best laboratory for investigating the formation, acceleration, and collimation of relativistic jets. A research team led by Silke Britzen from the Max Planck Institute for Radio Astronomy in Bonn, Germany, has found strong indication for turbulent processes connecting the accretion disk and the jet of that galaxy providing insights into the longstanding problem of the origin of astrophysical jets.

Supermassive black holes form some of the most enigmatic phenomena in astrophysics. Their enormous energy output is supposed to be generated by the...

Im Focus: A Quantum Low Pass for Photons

Physicists in Garching observe novel quantum effect that limits the number of emitted photons.

The probability to find a certain number of photons inside a laser pulse usually corresponds to a classical distribution of independent events, the so-called...

Im Focus: Microprocessors based on a layer of just three atoms

Microprocessors based on atomically thin materials hold the promise of the evolution of traditional processors as well as new applications in the field of flexible electronics. Now, a TU Wien research team led by Thomas Müller has made a breakthrough in this field as part of an ongoing research project.

Two-dimensional materials, or 2D materials for short, are extremely versatile, although – or often more precisely because – they are made up of just one or a...

All Focus news of the innovation-report >>>

Anzeige

Anzeige

Event News

Expert meeting “Health Business Connect” will connect international medical technology companies

20.04.2017 | Event News

Wenn der Computer das Gehirn austrickst

18.04.2017 | Event News

7th International Conference on Crystalline Silicon Photovoltaics in Freiburg on April 3-5, 2017

03.04.2017 | Event News

 
Latest News

NASA's Fermi catches gamma-ray flashes from tropical storms

25.04.2017 | Physics and Astronomy

Researchers invent process to make sustainable rubber, plastics

25.04.2017 | Materials Sciences

Transfecting cells gently – the LZH presents a GNOME prototype at the Labvolution 2017

25.04.2017 | Life Sciences

VideoLinks
B2B-VideoLinks
More VideoLinks >>>