As federal regulators are poised to propose the next round of fuel economy mandates, John DeCicco, a senior lecturer at the School of Natural Resources and Environment and faculty fellow with the Michigan Memorial Phoenix Energy Institute, says the most cost-effective answer is steady progress in advanced combustion engines and hybrid drive---but stopping short of plugging in and requiring super batteries or gaseous fuels.
He finds that the solution is in our garages if Americans shift gears in terms of priorities. What DeCicco calls a “revolution by evolution” avoids politically trendy breakthrough technologies that will remain too expensive for most consumers.
“If we really prioritize efficiency, we can get just as far with less sticker shock,” he said. “Evolutionary change can be of profound consequence for cutting oil use and greenhouse gas emissions, and do so with manageable costs and minimal risks for automakers.”
DeCicco has completed a study for The Energy Foundation examining how far fuel economy can be taken if it becomes a top priority in product planning. See the study here.
His analysis shows that optimizing internal combustion engines plus rising adoption of grid-free hybrids will enable new fleet efficiency to reach 52 mpg by 2025 and 74 mpg by 2035.
Reaching such a horizon would entail cultural change in a gearhead world attuned to nuances of power performance. DeCicco identifies emerging trends for what he dubs “efficiency compatible” design strategies, enticing buyers away from brute force and toward smart technologies, intelligent safety features and svelte styling. Amenities like Bluetooth hookups, communication bandwidth and other information technology enhance customer value with minimal demands on power.
The report develops new interpretations of technology cost estimates that better depict the benefits of ongoing innovation while acknowledging the limits of how much consumers can spend. The analysis reflects the three-way trade-off among efficiency, performance and cost that the car market is likely to face in the years ahead.
“The fleet I’ve modeled for 2025 does not give up any of the performance and creature comforts consumers already enjoy,” he said. “You don’t have to go back to being Fred Flintstone, but you will see lower fuel costs instead of ever more mass and muscle.”
At the U-M, DeCicco teaches courses in sustainable energy and transportation energy policy and researches solutions to transportation energy and climate problems. Before returning to academia, he was the green world’s top vehicle technology expert, most recently as senior fellow for automotive strategies at the Environmental Defense Fund.
DeCicco’s earlier studies of auto efficiency were influential in building the analytic foundation for major policy changes, including recent updates to Corporate Average Fuel Economy (CAFE) standards. He also pioneered environmental rating methodologies for motor vehicles as father of ACEEE's Green Book and designer of the Yahoo! Autos Green Ratings.
The Michigan Memorial Phoenix Energy Institute develops, coordinates and promotes multidisciplinary energy research and education.Contact:
John DeCicco: www.energy.umich.edu/res/fac_10/fac_DeCiccoJ10.html
John DeCicco | EurekAlert!
3D scans for the automotive industry
16.01.2017 | Julius-Maximilians-Universität Würzburg
Improvement of the operating range and increasing of the reliability of integrated circuits
09.11.2016 | Technologie Lizenz-Büro (TLB) der Baden-Württembergischen Hochschulen GmbH
Physicists from the University of Würzburg are capable of generating identical looking single light particles at the push of a button. Two new studies now demonstrate the potential this method holds.
The quantum computer has fuelled the imagination of scientists for decades: It is based on fundamentally different phenomena than a conventional computer....
An international team of physicists has monitored the scattering behaviour of electrons in a non-conducting material in real-time. Their insights could be beneficial for radiotherapy.
We can refer to electrons in non-conducting materials as ‘sluggish’. Typically, they remain fixed in a location, deep inside an atomic composite. It is hence...
Two-dimensional magnetic structures are regarded as a promising material for new types of data storage, since the magnetic properties of individual molecular building blocks can be investigated and modified. For the first time, researchers have now produced a wafer-thin ferrimagnet, in which molecules with different magnetic centers arrange themselves on a gold surface to form a checkerboard pattern. Scientists at the Swiss Nanoscience Institute at the University of Basel and the Paul Scherrer Institute published their findings in the journal Nature Communications.
Ferrimagnets are composed of two centers which are magnetized at different strengths and point in opposing directions. Two-dimensional, quasi-flat ferrimagnets...
An Australian-Chinese research team has created the world's thinnest hologram, paving the way towards the integration of 3D holography into everyday...
In the race to produce a quantum computer, a number of projects are seeking a way to create quantum bits -- or qubits -- that are stable, meaning they are not much affected by changes in their environment. This normally needs highly nonlinear non-dissipative elements capable of functioning at very low temperatures.
In pursuit of this goal, researchers at EPFL's Laboratory of Photonics and Quantum Measurements LPQM (STI/SB), have investigated a nonlinear graphene-based...
24.05.2017 | Event News
23.05.2017 | Event News
22.05.2017 | Event News
24.05.2017 | Physics and Astronomy
24.05.2017 | Physics and Astronomy
24.05.2017 | Event News