Rare earth metal enhances phosphate glass

“We wanted to get larger amounts of cerium into glass, because of its beneficial properties, and then investigate the properties of the glasses,” said Jen Rygel, graduate student in materials science and engineering.

Cerium exists in two states in glasses — cerium (III) and cerium (IV) — both states strongly absorb ultraviolet light. For years cerium has been added to silicate glass to enhance its ultraviolet absorbing capacity. The problem has always been that silicate glass can only dissolve so much cerium before it becomes saturated and can hold no more. Also, with high concentrations of cerium, silicate glass begins to turn yellow — an undesirable characteristic for such things as windows or sunglasses.

Phosphate glasses have a more flexible structure then silicate glasses, which allow higher percentages of cerium to be incorporated before it begins to color. Rygel, working with Carlo Pantano, distinguished professor of materials science and engineering, and director of Penn State's Materials Research Institute, synthesized and compared 11 glasses with varying concentrations of cerium, aluminum, phosphorus and silica.

They found that they could make phosphate glasses with 16 times more cerium oxide than silicate glasses while maintaining the same coloration and ability to absorb ultraviolet light. They published their work in today's (Dec. 15) issue of Non-Crystalline Solids.

“We were able to get a lot more cerium into our phosphate glass without sacrificing the optical transmission — they both still looked clear,” said Rygel.

The researchers could get more cerium into phosphate glass compared to silicate because of the different bonding networks silica and phosphorus form when made into glasses.

One explanation for why phosphate glass can incorporate more cerium than silicate glass without yellowing may be that the absorbing ranges for the two cerium states — cerium (III) and cerium (IV) — are shifted to absorb less blue light in phosphate glasses.

“A good example is in solar cells,” said Rygel. “The wavelengths that solar cells use aren't ultraviolet, and actually ultraviolet radiation can cause damage to the electronics of a solar cell. If you add cerium to the glass you can prevent the ultraviolet from getting down to the photovoltaic cells, potentially increasing their lifetime.”

To synthesize their glasses the researchers used a procedure called open-crucible melting. Raw materials such as phosphorus pentoxide, aluminum phosphate, cerium phosphate and silicon dioxide were combined in a crucible and heated in a high-temperature furnace to a temperature of 3000 degrees Fahrenheit melting the contents to a liquid.

“After it's all melted, we pull it out of the furnace and pour it into a graphite mold,” said Rygel. “The glass is then cooled down slowly so it doesn't break due to thermal stress.”

Cerium additions do not just block ultraviolet light. Increasing a glass' cerium concentration can also increase its resistance to radiation damage from x-rays and gamma rays by capturing freed electrons.

“Radiation can kick electrons free from atoms,” said Rygel. “You can see this by looking at what happens to a Coke bottle over time. It darkens because of radiation exposure.”

The proposed mechanisms for cerium's ability to block radiation are all based on cerium's two states and their ratio within the glass. Because of these implications Rygel wanted to know what percentages of each existed within her glasses.

Using X-ray photoelectron spectroscopy Rygel could determine whether the cerium in the glass was mostly in the cerium (III) or cerium (IV) oxidation state, or a ratio of the two. She found that all of her glasses contained approximately 95 percent cerium (III).

The National Science Foundation and the U.S. Air Force Research Laboratory supported this work.

Media Contact

A'ndrea Elyse Messer EurekAlert!

More Information:

http://www.psu.edu

All latest news from the category: Materials Sciences

Materials management deals with the research, development, manufacturing and processing of raw and industrial materials. Key aspects here are biological and medical issues, which play an increasingly important role in this field.

innovations-report offers in-depth articles related to the development and application of materials and the structure and properties of new materials.

Back to home

Comments (0)

Write a comment

Newest articles

Lighting up the future

New multidisciplinary research from the University of St Andrews could lead to more efficient televisions, computer screens and lighting. Researchers at the Organic Semiconductor Centre in the School of Physics and…

Researchers crack sugarcane’s complex genetic code

Sweet success: Scientists created a highly accurate reference genome for one of the most important modern crops and found a rare example of how genes confer disease resistance in plants….

Evolution of the most powerful ocean current on Earth

The Antarctic Circumpolar Current plays an important part in global overturning circulation, the exchange of heat and CO2 between the ocean and atmosphere, and the stability of Antarctica’s ice sheets….

Partners & Sponsors