Forum for Science, Industry and Business

Sponsored by:     3M 
Search our Site:

 

Algae could replace 17% of U.S. oil imports

14.04.2011
Choosing optimal growing locations limits algal biofuel’s water use

High oil prices and environmental and economic security concerns have triggered interest in using algae-derived oils as an alternative to fossil fuels. But growing algae — or any other biofuel source — can require a lot of water.

However, a new study shows that being smart about where we grow algae can drastically reduce how much water is needed for algal biofuel. Growing algae for biofuel, while being water-wise, could also help meet congressionally mandated renewable fuel targets by replacing 17 percent of the nation's imported oil for transportation, according to a paper published in the journal Water Resources Research.

Researchers at the Department of Energy's Pacific Northwest National Laboratory found that water use is much less if algae are grown in the U.S. regions that have the sunniest and most humid climates: the Gulf Coast, the Southeastern Seaboard and the Great Lakes.

"Algae has been a hot topic of biofuel discussions recently, but no one has taken such a detailed look at how much America could make - and how much water and land it would require — until now," said Mark Wigmosta, lead author and a PNNL hydrologist. "This research provides the groundwork and initial estimates needed to better inform renewable energy decisions."

Algal biofuel can be made by extracting and refining the oils, called lipids, that algae produce as they grow. Policy makers and researchers are interested in developing biofuels because they can create fewer overall greenhouse gas emissions than fossil fuels. And biofuels can be made here in the United States. In 2009, slightly more than half of the petroleum consumed by the U.S. was from foreign oil.

Wigmosta and his co-authors provide the first in-depth assessment of America's algal biofuel potential given available land and water. The study also estimated how much water would need to be replaced due to evaporation over 30 years. The team analyzed previously published data to determine how much algae can be grown in open, outdoor ponds of fresh water while using current technologies. Algae can also be grown in salt water and covered ponds. But the authors focused on open, freshwater ponds as a benchmark for this study. Much of today's commercial algae production is done in open ponds.

Crunching the numbers

First, the scientists developed a comprehensive national geographic information system database that evaluated topography, population, land use and other information about the contiguous United States. That database contained information spaced every 100 feet throughout the U.S., which is a much more detailed view than previous research. This data allowed them to identify available areas that are better suited for algae growth, such as those with flat land that isn't used for farming and isn't near cities or environmentally sensitive areas like wetlands or national parks.

Next, the researchers gathered 30 years of meteorological information. That helped them determine the amount of sunlight that algae could realistically photosynthesize and how warm the ponds would become. Combined with a mathematical model on how much typical algae could grow under those specific conditions, the weather data allowed Wigmosta and team to calculate the amount of algae that could realistically be produced hourly at each specific site.

Water for oil

The researchers found that 21 billion gallons of algal oil, equal to the 2022 advanced biofuels goal set out by the Energy Independence and Security Act, can be produced with American-grown algae. That's 17 percent of the petroleum that the U.S. imported in 2008 for transportation fuels, and it could be grown on land roughly the size of South Carolina. But the authors also found that 350 gallons of water per gallon of oil — or a quarter of what the country currently uses for irrigated agriculture — would be needed to produce that much algal biofuel.

The study also showed that up to 48 percent of the current transportation oil imports could be replaced with algae, though that higher production level would require significantly more water and land. So the authors focused their research on the U.S. regions that would use less water to grow algae, those with the nation's sunniest and most humid climates.

But the authors also found that algae's water use isn't that different from most other biofuel sources. While considering the gas efficiency of a standard light-utility vehicle, they estimated growing algae uses anywhere between 8.6 and 50.2 gallons of water per mile driven on algal biofuel. In comparison, data from previously published research indicated that corn ethanol can be made with less water, but showed a larger usage range: between 0.6 and 61.9 gallons of water per mile driven. Several factors — including the differing water needs of specific growing regions and the different assumptions and methods used by various researchers — cause the estimates to range greatly, they found.

Because conventional petroleum gas doesn't need to be grown like algae or corn, it doesn't need as much water. Previously published data indicated conventional gas uses between about 0.09 and 0.3 gallons of water per mile.

More to consider

Looking beyond freshwater, the authors noted algae has several advantages over other biofuel sources. For example, algae can produce more than 80 times more oil than corn per hectare a year. And unlike corn and soybeans, algae aren't a widespread food source that many people depend on for nutrition. As carbon dioxide-consuming organisms, algae are considered a carbon-neutral energy source. Algae can feed off carbon emissions from power plants, delaying the emissions' entry into the atmosphere. Algae also digest nitrogen and phosphorous, which are common water pollutants. That means algae can also grow in — and clean — municipal waste water.

"Water is an important consideration when choosing a biofuel source," Wigmosta said. "And so are many other factors. Algae could be part of the solution to the nation's energy puzzle — if we're smart about where we place growth ponds and the technical challenges to achieving commercial-scale algal biofuel production are met."

Next up for Wigmosta and his colleagues is to examine non-freshwater sources like salt water and waste water. They are also researching greenhouse ponds for use in colder climates, as well as economic considerations for algal biofuel production.

The paper describes research funded by DOE's Office of Energy Efficiency and Renewable Energy.

REFERENCE: Mark S. Wigmosta, Andre M. Coleman, Richard J. Skaggs, Michael H. Huesemann, Leonard J. Lane. National Microalgae Biofuel Production Potential and Resource Demand. Water Resources Research. Published online April 13, 2011.http://www.agu.org/journals/wr/wr1104/2010WR009966/. DOI:10.1029/2010WR009966

Franny White | EurekAlert!
Further information:
http://www.pnl.gov

More articles from Studies and Analyses:

nachricht Physics of bubbles could explain language patterns
25.07.2017 | University of Portsmouth

nachricht Obstructing the ‘inner eye’
07.07.2017 | Friedrich-Schiller-Universität Jena

All articles from Studies and Analyses >>>

The most recent press releases about innovation >>>

Die letzten 5 Focus-News des innovations-reports im Überblick:

Im Focus: Carbon Nanotubes Turn Electrical Current into Light-emitting Quasi-particles

Strong light-matter coupling in these semiconducting tubes may hold the key to electrically pumped lasers

Light-matter quasi-particles can be generated electrically in semiconducting carbon nanotubes. Material scientists and physicists from Heidelberg University...

Im Focus: Flexible proximity sensor creates smart surfaces

Fraunhofer IPA has developed a proximity sensor made from silicone and carbon nanotubes (CNT) which detects objects and determines their position. The materials and printing process used mean that the sensor is extremely flexible, economical and can be used for large surfaces. Industry and research partners can use and further develop this innovation straight away.

At first glance, the proximity sensor appears to be nothing special: a thin, elastic layer of silicone onto which black square surfaces are printed, but these...

Im Focus: 3-D scanning with water

3-D shape acquisition using water displacement as the shape sensor for the reconstruction of complex objects

A global team of computer scientists and engineers have developed an innovative technique that more completely reconstructs challenging 3D objects. An ancient...

Im Focus: Manipulating Electron Spins Without Loss of Information

Physicists have developed a new technique that uses electrical voltages to control the electron spin on a chip. The newly-developed method provides protection from spin decay, meaning that the contained information can be maintained and transmitted over comparatively large distances, as has been demonstrated by a team from the University of Basel’s Department of Physics and the Swiss Nanoscience Institute. The results have been published in Physical Review X.

For several years, researchers have been trying to use the spin of an electron to store and transmit information. The spin of each electron is always coupled...

Im Focus: The proton precisely weighted

What is the mass of a proton? Scientists from Germany and Japan successfully did an important step towards the most exact knowledge of this fundamental constant. By means of precision measurements on a single proton, they could improve the precision by a factor of three and also correct the existing value.

To determine the mass of a single proton still more accurate – a group of physicists led by Klaus Blaum and Sven Sturm of the Max Planck Institute for Nuclear...

All Focus news of the innovation-report >>>

Anzeige

Anzeige

Event News

Clash of Realities 2017: Registration now open. International Conference at TH Köln

26.07.2017 | Event News

Closing the Sustainability Circle: Protection of Food with Biobased Materials

21.07.2017 | Event News

»We are bringing Additive Manufacturing to SMEs«

19.07.2017 | Event News

 
Latest News

CCNY physicists master unexplored electron property

26.07.2017 | Physics and Astronomy

Molecular microscopy illuminates molecular motor motion

26.07.2017 | Life Sciences

Large-Mouthed Fish Was Top Predator After Mass Extinction

26.07.2017 | Earth Sciences

VideoLinks
B2B-VideoLinks
More VideoLinks >>>